{"product_id":"black-sequential-led-light-bar-tail-lights-honda-s2000-2000-2009","title":"Black Sequential LED Light Bar Tail Lights for Honda S2000 (2000-2009)","description":"\u003cp\u003eStock S2000 tails look dated from behind—this black housing LED light bar set gives the AP1 and AP2 rear a sharp red bar signature and a sequential amber sweep. GENSSI's S2000 kit is a vehicle-specific complete tail light pair with AP1 \/ AP2 conversion hardware included and plug-and-play factory connection.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eImportant Fitment Note:\u003c\/strong\u003e Fits both the AP1 (2000-2003) and AP2 (2004-2009) S2000. The included AP1 \/ AP2 conversion hardware adapts the lamp to your chassis.\u003c\/p\u003e\n\u003ch2\u003eFitment\u003c\/h2\u003e\n\u003ctable\u003e\n\u003cthead\u003e\u003ctr\u003e\n\u003cth\u003eYEAR\u003c\/th\u003e\n\u003cth\u003eMAKE \/ MODEL\u003c\/th\u003e\n\u003cth\u003eFITS\u003c\/th\u003e\n\u003c\/tr\u003e\u003c\/thead\u003e\n\u003ctbody\u003e\n\u003ctr\u003e\n\u003ctd\u003e2000-2003\u003c\/td\u003e\n\u003ctd\u003eHonda \/ S2000 AP1\u003c\/td\u003e\n\u003ctd\u003eYes\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003e2004-2009\u003c\/td\u003e\n\u003ctd\u003eHonda \/ S2000 AP2\u003c\/td\u003e\n\u003ctd\u003eYes\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003c\/tbody\u003e\n\u003c\/table\u003e\n\u003ch2\u003eSpecs\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003eStyle: Black housing, clear lens, full LED light bar with sequential amber turn signal\u003c\/li\u003e\n\u003cli\u003eBulbs: Built-in LEDs — red brake \/ parking light bar, amber sequential turn signal, white reverse. No bulbs required\u003c\/li\u003e\n\u003cli\u003eSold as: Black sequential LED light bar tail light pair\u003c\/li\u003e\n\u003cli\u003eFit: Direct-fit black LED light bar tails for 2000-2009 Honda S2000 AP1 and AP2\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eInterchange\u003c\/h2\u003e\n\u003cp\u003e33551-S2A-A02, 33551-S2A-A11\u003c\/p\u003e\n\u003ch2\u003eWhat's included\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003e1x Driver black sequential LED light bar tail light\u003c\/li\u003e\n\u003cli\u003e1x Passenger black sequential LED light bar tail light\u003c\/li\u003e\n\u003cli\u003ex2 AP1 \/ AP2 conversion hardware sets (driver + passenger)\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eInstallation — Honda S2000 AP1 \/ AP2 (2000-2009)\u003c\/h2\u003e\n\u003col\u003e\n\u003cli\u003ePark on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.\u003c\/li\u003e\n\u003cli\u003eOpen the trunk and pull back the trunk trim panel behind each tail light (push-pin fasteners on the rear and side trim). Disconnect the connectors from the factory tail light.\u003c\/li\u003e\n\u003cli\u003eRemove the four 8 mm mounting nuts from each factory tail light and pull the lamp straight out of the body opening.\u003c\/li\u003e\n\u003cli\u003eFit the included AP1 or AP2 conversion hardware to the new lamp for your chassis and connect the included wire adapters to the factory connectors. Check that the foam gasket is seated flat; replace it if it is distorted or stays compressed.\u003c\/li\u003e\n\u003cli\u003ePress the new lamp's studs through the body holes, thread the four 8 mm nuts from inside the trunk, and refit the trim.\u003c\/li\u003e\n\u003cli\u003eReconnect the battery, test brake, parking, sequential turn, and reverse on both sides, then run water over the lamps to confirm there are no leaks.\u003c\/li\u003e\n\u003c\/ol\u003e\n\u003ch3\u003eBuyer FAQ\u003c\/h3\u003e\n\u003cp\u003e\u003cstrong\u003eWill these fit both AP1 and AP2 S2000s?\u003c\/strong\u003e Yes. The kit includes separate AP1 and AP2 conversion hardware, so the same lamp covers 2000-2003 and 2004-2009 cars.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eIs this a cover or a full tail light?\u003c\/strong\u003e A full replacement assembly. The red light bar, amber sequential turn signal, and white reverse are built-in LEDs inside a black housing with a clear lens—no overlay, no bulb swap.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eHow does the sequential signal look on the road?\u003c\/strong\u003e The amber turn signal sweeps across the lamp one segment at a time, so cars behind you read your turn direction instantly, even in daylight.\u003c\/p\u003e","brand":"GENSSI","offers":[{"title":"Default Title","offer_id":68230964445267,"sku":"DS-S2000-TAIL-BLK-SEQ-LED-BAR-2000-2009","price":769.95,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0685\/9348\/3859\/files\/hero-s2000-blk-clr-led-bar-tail-2000-2009.jpg?v=1795058382","url":"https:\/\/genssi.com\/es\/products\/black-sequential-led-light-bar-tail-lights-honda-s2000-2000-2009","provider":"GENSSI","version":"1.0","type":"link"}