{"product_id":"frosted-clear-lens-tail-lights-4pc-w-bulbs-chevy-camaro-2010-2013","title":"Frosted Clear Lens Tail Lights 4pc w\/ Bulbs for Chevy Camaro (2010-2013)","description":"\u003cp\u003eStock fifth-gen Camaro tails read dark and heavy from behind—this frosted clear set gives the car a bright, clean all-clear rear end that still lights red when you brake. GENSSI's Camaro kit is a vehicle-specific 4pc set of outer and inner lamps that plugs into the factory harness with no rewiring and includes red bulbs.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eImportant Fitment Note:\u003c\/strong\u003e Fits the 2010-2013 (fifth-generation) Chevy Camaro. The 2016-2024 Camaro uses a different tail light and is not compatible.\u003c\/p\u003e\n\u003ch2\u003eFitment\u003c\/h2\u003e\n\u003ctable\u003e\n\u003cthead\u003e\u003ctr\u003e\n\u003cth\u003eYEAR\u003c\/th\u003e\n\u003cth\u003eMAKE \/ MODEL\u003c\/th\u003e\n\u003cth\u003eFITS\u003c\/th\u003e\n\u003c\/tr\u003e\u003c\/thead\u003e\n\u003ctbody\u003e\n\u003ctr\u003e\n\u003ctd\u003e2010-2013\u003c\/td\u003e\n\u003ctd\u003eChevrolet \/ Camaro (LS, LT, SS, ZL1)\u003c\/td\u003e\n\u003ctd\u003eYes\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003e2016-2024\u003c\/td\u003e\n\u003ctd\u003eChevrolet \/ Camaro\u003c\/td\u003e\n\u003ctd\u003eNo\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003c\/tbody\u003e\n\u003c\/table\u003e\n\u003ch2\u003eSpecs\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003eStyle: All-clear frosted lens — OE frosted look with a brighter, whiter rear end; polycarbonate lens with UV and impact protection\u003c\/li\u003e\n\u003cli\u003eBulbs: Incandescent, x4 3157 red parking \/ brake \/ turn signal bulbs included. Reverse bulbs and sockets not included — reuse your factory reverse bulbs and sockets\u003c\/li\u003e\n\u003cli\u003eSold as: 4pc set: left and right outer lamps + left and right inner lamps, with 4 red bulbs\u003c\/li\u003e\n\u003cli\u003eFit: Direct-fit frosted clear tails for 2010-2013 Chevy Camaro, all models\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eInterchange\u003c\/h2\u003e\n\u003cp\u003e92244323, 92244324, 92244320, 92244322, 92244325, 92244319, 92244321, 92244326\u003c\/p\u003e\n\u003ch2\u003eWhat's included\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003e1x Driver outer frosted clear tail light\u003c\/li\u003e\n\u003cli\u003e1x Passenger outer frosted clear tail light\u003c\/li\u003e\n\u003cli\u003e1x Driver inner frosted clear tail light\u003c\/li\u003e\n\u003cli\u003e1x Passenger inner frosted clear tail light\u003c\/li\u003e\n\u003cli\u003ex4 3157 red bulbs\u003c\/li\u003e\n\u003c\/ul\u003e\n\n\u003ch2\u003eInstallation — Chevy Camaro (2010-2013)\u003c\/h2\u003e\n\u003col\u003e\n\u003cli\u003eOpen the trunk. On one side, lift the centers of the three plastic tabs on the tail-lamp closeout panel with a trim tool, then pull the panel off. Pry the lamp bezel off with the same tool.\u003c\/li\u003e\n\u003cli\u003eUnplug the connector. Remove the three 10 mm nuts. On the outer lamp, the nut farthest toward the quarter is tight to reach. Take the two easier nuts off first, push the housing slightly forward, and finish that outer nut by hand.\u003c\/li\u003e\n\u003cli\u003ePull the housing straight out. Do the inner lamp on that side the same way: closeout tabs, bezel, connector, three 10 mm nuts. This kit replaces the inner and outer lamp on each side.\u003c\/li\u003e\n\u003cli\u003eTwist the factory sockets out of the old housings and seat them in the new housings. Install the bulbs from the kit in those sockets, then plug the connector in.\u003c\/li\u003e\n\u003cli\u003eSet the housing on the studs so the locating pins sit in the bumper and snug the three 10 mm nuts. These nuts do not take much torque. Refit the bezel and the closeout panel.\u003c\/li\u003e\n\u003cli\u003eRepeat on the other side. Check tail, brake, turn, and reverse with the trunk open before the last panel goes back in.\u003c\/li\u003e\n\u003c\/ol\u003e\n\u003ch3\u003eBuyer FAQ\u003c\/h3\u003e\n\u003cp\u003e\u003cstrong\u003eWill the lamps still light red when I brake?\u003c\/strong\u003e Yes. The lens is clear, and the included 3157 red bulbs supply the red brake, parking, and signal color, so the lamps look bright and frosted when off and red when lit.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eDo I have to splice any wiring?\u003c\/strong\u003e No. The lamps are built for plug-and-play fitment with the factory harness, with no re-wiring. Reverse bulbs and sockets are not included, so move your factory reverse bulbs and sockets over.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eWhich Camaros fit, and what is in the box?\u003c\/strong\u003e The 2010-2013 Camaro, all models. You get four lamps (outer and inner, left and right) plus four 3157 red bulbs, matching OEM outer 92244323 (left) and 92244324 (right), and inner 92244320 \/ 92244322 \/ 92244325 (left) and 92244319 \/ 92244321 \/ 92244326 (right).\u003c\/p\u003e","brand":"GENSSI","offers":[{"title":"Default Title","offer_id":68237395918931,"sku":"DS-CAMARO-TAIL-FROSTED-CLR-4PC-2010-2013","price":279.95,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0685\/9348\/3859\/files\/hero-camaro-10-13-frosted-clear-tail-4pc-2010-2013.jpg?v=1795124607","url":"https:\/\/genssi.com\/fr\/products\/frosted-clear-lens-tail-lights-4pc-w-bulbs-chevy-camaro-2010-2013","provider":"GENSSI","version":"1.0","type":"link"}