{"product_id":"clear-lens-tail-lights-pair-w-bulbs-honda-civic-coupe-2006-2011","title":"Clear Lens Tail Lights Pair w\/ Bulbs for Honda Civic Coupe (2006-2011)","description":"\u003cp\u003eStock red tails make an 8th-generation Civic coupe look like every other one in the lot—this all-clear lens pair gives the rear a bright white-out look, and the red, amber, and clear bulbs are already in the box. GENSSI's Civic coupe set is a vehicle-specific left and right assembly pair that replaces the factory outer lamps directly and reuses your existing sockets.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eImportant Fitment Note:\u003c\/strong\u003e Fits the 2006-2011 Honda Civic 2-door coupe (FG1 \/ FG2), all models. The 2006-2011 Civic 4-door sedan uses a different tail light and is not compatible.\u003c\/p\u003e\n\u003ch2\u003eFitment\u003c\/h2\u003e\n\u003ctable\u003e\n\u003cthead\u003e\u003ctr\u003e\n\u003cth\u003eYEAR\u003c\/th\u003e\n\u003cth\u003eMAKE \/ MODEL\u003c\/th\u003e\n\u003cth\u003eFITS\u003c\/th\u003e\n\u003c\/tr\u003e\u003c\/thead\u003e\n\u003ctbody\u003e\n\u003ctr\u003e\n\u003ctd\u003e2006-2011\u003c\/td\u003e\n\u003ctd\u003eHonda \/ Civic 2-Door Coupe, all models\u003c\/td\u003e\n\u003ctd\u003eYes\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003ctr\u003e\n\u003ctd\u003e2006-2011\u003c\/td\u003e\n\u003ctd\u003eHonda \/ Civic 4-Door Sedan\u003c\/td\u003e\n\u003ctd\u003eNo\u003c\/td\u003e\n\u003c\/tr\u003e\n\u003c\/tbody\u003e\n\u003c\/table\u003e\n\u003ch2\u003eSpecs\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003eStyle: Chrome housing with an all-clear lens and clear reflectors; polycarbonate lens with UV protection and high impact resistance\u003c\/li\u003e\n\u003cli\u003eBulbs: Incandescent. Bulbs included: 2x 7443 red (brake \/ parking), 2x 7440 amber (turn signal), and 2x 921 clear (reverse). Sockets are not included — reuse the factory sockets\u003c\/li\u003e\n\u003cli\u003eSold as: Pair — left and right outer tail light assemblies with 6 bulbs\u003c\/li\u003e\n\u003cli\u003eFit: Direct replacement for all 2006-2011 Honda Civic 2-door coupe models; plug and play, no re-wiring\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eInterchange\u003c\/h2\u003e\n\u003cp\u003e33551-SVA-A02, 33551-SVA-A51, 33501-SVA-A02, 33501-SVA-A51\u003c\/p\u003e\n\u003ch2\u003eWhat's included\u003c\/h2\u003e\n\u003cul\u003e\n\u003cli\u003e1x Driver (left) all-clear tail light assembly\u003c\/li\u003e\n\u003cli\u003e1x Passenger (right) all-clear tail light assembly\u003c\/li\u003e\n\u003cli\u003e2x 7443 red bulbs\u003c\/li\u003e\n\u003cli\u003e2x 7440 amber bulbs\u003c\/li\u003e\n\u003cli\u003e2x 921 clear bulbs\u003c\/li\u003e\n\u003c\/ul\u003e\n\u003ch2\u003eInstallation — Honda Civic Coupe (2006-2011)\u003c\/h2\u003e\n\u003col\u003e\n\u003cli\u003eOpen the trunk. Remove the three plastic trim screws on the trunk side trim with a flat-blade screwdriver, pull out their receivers, and fold the carpet back to expose the back of the lamp.\u003c\/li\u003e\n\u003cli\u003eUnplug each harness connector from the lamp by pressing its lock tab. The connectors are keyed and only fit one spot. Pop the plastic harness retainers off the studs with a trim tool, then remove the four 8 mm nuts with a deep socket.\u003c\/li\u003e\n\u003cli\u003eRemove the rear bumper cover on the lamp side so you can reach the last fastener: pry out the two push clips under the bumper, remove the Phillips screw in the wheel-arch liner, remove the 5 mm Allen (flat-head) bolt on the trunk-lid lip, and pull the cover out of its retaining clips from the side.\u003c\/li\u003e\n\u003cli\u003eRemove the Phillips screw under the lamp and pull the lamp's locating pins out of the body bracket. If the bracket binds, remove its two 10 mm nuts.\u003c\/li\u003e\n\u003cli\u003eTwist each bulb socket 45 degrees counterclockwise out of the old lamp and fit it into the new one with the included bulbs: 7443 red for brake \/ parking, 7440 amber for turn signal, 921 clear for reverse. Sockets are not in the box. Install the bulbs before mounting the lamp, because one socket is hard to reach with the lamp on the car.\u003c\/li\u003e\n\u003cli\u003eSet the new lamp's pins into the bracket, install the Phillips screw, and start the four 8 mm nuts by hand before snugging them. Check that the foam gasket is not distorted. Reconnect the connectors, then refit the bumper cover and trunk trim. Test every function and run water over the lamp to confirm it seals.\u003c\/li\u003e\n\u003c\/ol\u003e\n\u003ch3\u003eBuyer FAQ\u003c\/h3\u003e\n\u003cp\u003e\u003cstrong\u003eIs this a cheap clear cover or a full tail light?\u003c\/strong\u003e A full replacement assembly pair with a polycarbonate all-clear lens and clear reflectors in a chrome housing. It replaces the factory outer lamp outright instead of sitting over it, and the lens has UV protection and high impact resistance.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eDo I need to wire or splice anything?\u003c\/strong\u003e No re-wiring. The lamps are plug and play and use your factory bulb sockets. Six bulbs are included (red 7443, amber 7440, and clear 921), so you only move your sockets over.\u003c\/p\u003e\n\u003cp\u003e\u003cstrong\u003eWhich Civic fits, and what is in the box?\u003c\/strong\u003e The 2006-2011 Honda Civic 2-door coupe, all models. The 4-door sedan does not fit. You get a left and right lamp plus six bulbs, matching OEM 33551-SVA-A02 \/ 33551-SVA-A51 on the left and 33501-SVA-A02 \/ 33501-SVA-A51 on the right.\u003c\/p\u003e","brand":"GENSSI","offers":[{"title":"Default Title","offer_id":68237770555475,"sku":"DS-CIVIC-COUPE-TAIL-CLR-PAIR-2006-2011","price":237.95,"currency_code":"USD","in_stock":true}],"thumbnail_url":"\/\/cdn.shopify.com\/s\/files\/1\/0685\/9348\/3859\/files\/hero-civic-coupe-clear-tail-pair-2006-2011.jpg?v=1795128235","url":"https:\/\/genssi.com\/products\/clear-lens-tail-lights-pair-w-bulbs-honda-civic-coupe-2006-2011","provider":"GENSSI","version":"1.0","type":"link"}