All Clear Red LED Tail Lights 4pc for Lexus LS400 (1995-1997)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Muted stock UCF20 reds hide the LS rear—this all-clear red LED 4pc set puts a sharper, brighter signature on the 1995-1997 LS400. GENSSI's Lexus LS400 kit is a vehicle-specific outer+inner clear LED set that bolts in and plugs into the factory harness.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 1995-1997 | Lexus / LS400 UCF20 | Yes |
Specs
- Style: Chrome housing, all-clear lens with red LED sections (outer + inner)
- Bulbs: LED / Incandescent hybrid — LED sections with remaining socketed bulbs; x6 LED resistors included
- Sold as: All-clear red LED 4pc outer + inner tail light set
- Fit: Direct-fit all-clear red LED 4pc tails for 1995-1997 Lexus LS400 UCF20
Interchange
81561-50040, 81560-50040, 81591-50040, 81590-50040, 81551-50040, 81550-50040, 81581-50040, 81580-50040
What's included
- 1x Driver outer all-clear LED tail light
- 1x Passenger outer all-clear LED tail light
- 1x Driver inner all-clear LED tail light
- 1x Passenger inner all-clear LED tail light
- x6 LED resistors
Installation — Lexus LS400 UCF20 (1995-1997)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the trunk. Pull back the rear side and deck trim to reach the outer and inner tail light fasteners and harness connectors.
- Disconnect each harness. Remove the mounting fasteners and slide the factory outer and inner assemblies straight back out of the body openings.
- Seat each new all-clear LED assembly, connect the included resistors per the harness labeling, reconnect the plugs, and snug the fasteners while checking quarter-panel and deck gaps.
- Refit the trunk trim, reconnect the battery, and test parking, brake, turn, and reverse on both sides.
Buyer FAQ
Is this outer and inner? Yes. The kit is four assemblies—left/right outer plus left/right inner for the UCF20 rear.
Why are resistors included? Six LED resistors are included for the LED sections so the factory turn / brake circuits stay stable after the swap.
Do I splice wiring? No. After trunk access, the assemblies bolt in and plug into the factory harness with the included resistors inline as labeled.