GENSSI hero — black clear LED tail lights 4pc Honda CR-V (2017-2022) white background

Black Clear LED Tail Lights 4pc for Honda CR-V (2017-2022)

$657.95
Skip to product information
GENSSI hero — black clear LED tail lights 4pc Honda CR-V (2017-2022) white background

Black Clear LED Tail Lights 4pc for Honda CR-V (2017-2022)

$657.95
DS-CRV-TAIL-BLK-CLR-LED-4PC-2017-2022

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Stock red CR-V tails read busy on a fifth-gen rear—black housings with clear lenses and a sharp LED signature clean that look up by day and hit hard on the brake at night. GENSSI's 2017-2022 Honda CR-V 4-piece set replaces the outer and inner factory assemblies with vehicle-specific LED lamps that bolt in and plug into the factory harness.

Important Fitment Note: This is a complete 4-piece black-housing clear-lens LED set for 2017-2022 Honda CR-V (outer quarter + inner liftgate, left and right)—not outer-only and not a smoke overlay.

Fitment

YEAR MAKE / MODEL FITS
2017-2022 Honda / CR-V Yes

Specs

  • Style: Black housing, all-clear lens, full LED parking/brake + amber LED signal
  • Bulbs: Built-in LED parking/brake and amber LED signal; 921 reverse — reuse factory reverse bulbs
  • Sold as: 4-piece set (inner & outer, left & right)
  • Fit: Direct replacement 4pc set — plugs into factory connectors

Interchange

33500-TLA-A01, 33550-TLA-A01, 34150-TLA-A01, 34155-TLA-A01, HO2804113, HO2805113, HO2802116

What's included

  • 1x Driver outer tail light
  • 1x Passenger outer tail light
  • 1x Driver inner (liftgate) tail light
  • 1x Passenger inner (liftgate) tail light

Installation — Honda CR-V (2017-2022)

  1. Park on level ground, set the parking brake, switch lights and ignition off, and open the liftgate.
  2. Outer lamps: from the cargo opening, remove the two 8 mm bolts securing each outer quarter lamp, pull the housing straight rearward off the locator pins, and disconnect the harness.
  3. Seat each new outer clear LED lamp on the pins, reconnect until it clicks, and snug the 8 mm bolts—do not overtighten plastic studs.
  4. Inner liftgate lamps: remove the liftgate trim access as needed, unbolt each inner lamp, disconnect the connector, and pull the housing free.
  5. Install the matching inner clear LED lamps, reconnect plugs, and refit fasteners and trim.
  6. Test running, brake, turn, and reverse on all four lamps before closing the liftgate.

Buyer FAQ

Is this outer lamps only? No. You get all four assemblies—left and right outer quarter lamps plus left and right inner liftgate lamps.

Will these look like cheap tint covers? No. These are full black-housing clear LED assemblies that replace the factory housings—not stick-on overlays.

Do I splice wiring? No. Outer and inner lamps bolt into the factory openings and plug into the stock harnesses.

You may also like