Black Halogen Headlights Pair with LED Low Beam for Ford Explorer Police Interceptor Utility (2016-2018)

Replace faded or cracked factory lamps on your 2016-2018 Police Interceptor Utility with this black-housing pair. Each lamp has a halogen high beam, an LED low beam (reuse your original LED module), comes with a 9005 high-beam bulb, bolts to the factory points, and plugs into the factory connectors, with no splicing.

Fitment

Specs

• Sold as: driver and passenger pair (two lamps)
• Housing: black, clear lens, amber reflector
• High beam: halogen, 9005 bulb included
• Low beam: LED — reuse your original LED module; the module is not included
• DOT and SAE compliant
• Plugs into the factory connectors (no splicing)

In the Box

• Driver-side halogen/LED-low-beam headlight (FB5Z13008AH style)
• Passenger-side halogen/LED-low-beam headlight (FB5Z13008AJ style)
• 9005 halogen high-beam bulbs (already installed)

Interchange References

Replaces the original assemblies commonly crossed with FB5Z13008AH, FB5Z13008AJ, FB5Z13008U, FB5Z13008L.

Installation: Ford Police Interceptor Utility and Explorer (2016-2018)

On the 2016-2018 Police Interceptor Utility and Explorer the front bumper cover comes off so you can reach the headlight bolts. The procedure is the same on both sides. Turn the lights and ignition off before you start. Transfer the original LED low-beam module into each new lamp before you install it.

1. Open the hood. Remove the upper bumper-cover and grille fasteners, the screws along the lower edge, and the clips and screws in each wheel arch and at the fender corners.
2. Release the bumper cover at the fenders, unplug any bumper lamps or sensors as equipped, and set the cover aside.
3. Disconnect the factory connectors. Remove the headlight mounting bolts and slide the lamp forward.
4. Move the original LED low-beam module into the new lamp. Plug the new lamp in, seat the locating points, and start all bolts by hand before tightening them evenly. Check for an even gap to the fender and hood.
5. Refit the bumper cover. Test low beam, high beam and the turn signal, then aim the beams.

Frequently Asked Questions

Which vehicles do these headlights fit?
2016-2018 Ford Police Interceptor Utility, and Explorer models with the headlamp prep pack and no factory full LED lamps, built through April 4, 2018 (FB5Z13008AH / FB5Z13008AJ). They do not fit vehicles built after that date or factory full-LED civilian Explorer lamps. Compare your current lamps and build date before ordering.

Is this a pair or a single lamp?
This is a complete driver and passenger pair, two lamps.

Will these fit a civilian Explorer with factory LED headlights?
No. Those use different full-LED housings. Use our chrome LED pair for Limited, Platinum and XLT, our black LED pair for Sport, or our chrome LED pair without LED DRL for Base.

Is the LED module included?
No. Reuse the original LED low-beam module from your current lamps. A 9005 halogen high-beam bulb is included in each lamp.

What bulb sizes do these headlights use?
High beam uses a 9005 halogen bulb (included). The low beam is LED and is not a replaceable bulb; reuse your original LED module.

Do I need to cut or splice any wiring?
No. Each lamp plugs into the factory connectors.

How are they installed on a 2016-2018 Police Interceptor Utility?
The front bumper cover comes off so you can reach the headlight bolts. Transfer the original LED module, disconnect the connectors, install the new lamp, refit the cover and aim the beams afterward.