Black Halogen Projector Headlights Pair w/ LED DRL & Bulbs for Chrysler 300 (2015-2023)

Replace yellowed or cracked headlights on your 2015-2023 Chrysler 300 with factory halogen projectors with this brand-new pair of black halogen projector headlights with LED DRL, bulbs included.

Fitment

Will NOT fit: HID/AFS cars with the 12-pin connector; 2011-2014 Chrysler 300.

Common Reasons to Replace

• Yellowed, hazy, or oxidized lenses reducing light output
• Cracked lens or broken mounting tabs
• Moisture or condensation inside the housing
• Collision damage

Specs

• Housing: Black
• High/low beam: HIR2 (9012)
• Turn signal: PSY24W
• DRL: LED
• Connector: 9-pin
• DOT compliant
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: 68214383AD, 68214383AB, 68214383AC, 68214382AB, 68214382AC. Partslink: CH2502331, CH2503331, CH2503269, CH2502269.

What's Included

• 1 x Driver side headlight assembly
• 1 x Passenger side headlight assembly
• HIR2 (9012) and PSY24W bulbs included

Installation

1. Disconnect the battery. Raise and support the car and remove the front splash shields and belly pan.
2. Remove the fascia-to-fender fasteners in each wheel opening and unplug the fog lamps.
3. Lower the car, remove the push-pin retainers along the upper radiator support, pull the fascia out of the fender brackets and lift it off with a helper.
4. Remove the four headlamp screws (two upper, two lower), pull the lamp forward and unplug it. Move any brackets to the new lamp.
5. Install the new lamp, refit the fascia and shields, and aim the headlights.

Steps compiled from Mopar service procedure (13 - Front Fascia removal), 300CForums headlamp removal thread and CarClubsUSA 2015 300 headlight guide. Professional installation and headlight aiming are recommended.

FAQs

What bulb sizes do these headlights use?
Per the listing bulb chart: HIR2 (9012) high/low beam and PSY24W turn signal, both included; the DRL is built-in LED.

How do I know if my 300 matches?
Check the plug on the back of your headlight: per the listing, the 9-pin connector matches and the 12-pin (HID) connector does not.

Do I need to remove the front bumper to replace these headlights?
Yes. On the 2015-2023 Chrysler 300 the front fascia comes off (splash shields, belly pan, fascia-to-fender fasteners and radiator-support push pins). The lamp is then held by four screws, two upper and two lower.

Can I install HID or LED kits?
Yes. This is a halogen housing, so a plug-in LED or HID kit in your factory bulb size can be used. Aim the headlights afterward.