Black HID Projector Headlights Pair w/ LED DRL for Chevy Impala (2014-2020)

Replace yellowed or cracked HID headlights on your 2014-2020 Chevrolet Impala with this brand-new pair of black HID projector headlights with LED DRL. Reuse your factory D3S bulbs and ballasts.

Fitment

Will NOT fit: Halogen Impala (7-pin plug); 2014-2016 Impala Limited.

Common Reasons to Replace

• Yellowed, hazy, or oxidized lenses reducing light output
• Cracked lens or broken mounting tabs
• Moisture or condensation inside the housing
• Collision damage

Specs

• Housing: Black
• Low/high beam: D3S HID (not included)
• Side marker: 194
• Turn signal: WY21/5W
• DRL: LED
• DOT compliant
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: 23405241, 19434732, 23272815, 23489572, 84160413, 19434731, 23272814, 23405240, 23489571. Partslink: GM2503411, GM2502411.

What's Included

• 1 x Driver side headlight assembly
• 1 x Passenger side headlight assembly
• 194 side marker and WY21/5W turn bulbs
• Half assembly: HID bulbs, ballasts, and high-voltage wires are NOT included; reuse yours

Installation

1. Disconnect the battery. Remove the radiator/hood-latch sight shield and its clips.
2. Remove the upper fascia bolts, the two bolts at the fascia-to-fender joints near the headlights and the lower bolts/clips to the chassis.
3. Turn the wheels, pull back the front wheel liners, remove the corner bolts and unsnap the fascia from the fenders. Pull it forward and unplug the wiring.
4. Remove the four headlamp screws, unplug the lamp and lift it out.
5. Move your D3S bulbs and ballasts to the new lamps, install in reverse, check all lights and aim.

Steps compiled from Impala Forums "Headlight and front clip removal" thread and Remont-bampera 2014-2020 Impala bumper guide. Professional installation and headlight aiming are recommended.

FAQs

What bulbs do these headlights use?
Per the listing: D3S low/high beam (not included, reuse yours). The 194 side marker and WY21/5W turn signal bulbs are included.

Will these fit an Impala with halogen headlights?
No. Per the listing match photo these are for HID cars with the 8-pin plug; halogen cars use a 7-pin plug.

Do I need to remove the front bumper to replace these headlights?
Yes. On the 2014-2020 Impala the front fascia comes off: the under-hood sight shield, the upper fascia bolts, the bolts at the fender seams, the lower and wheel-liner fasteners. The headlamp is then held by four screws.

Can I install HID or LED kits?
Not applicable. These are factory-style HID/Xenon housings; reuse your factory HID bulbs and ballasts.