Black Sequential LED Tail Lights Pair for Ford F-150 Styleside (2004-2008)
$339.95
Skip to product information
Black Sequential LED Tail Lights Pair for Ford F-150 Styleside (2004-2008)
$339.95
DS-PT0038A-S
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Give your 2004-2008 Ford F-150 Styleside a modern rear end with this black-housing LED tail light pair. A full light-guide running lamp, bright LED brake section, sequential turn signal and clear LED reverse light replace the factory bulb-type lamps, bolting into the original mounting points.
Fitment
| Year | Make / Model | Fits |
|---|---|---|
| 2004-2008 | Ford / F-150 | Styleside bed only; not Flareside; not 2004 F-150 Heritage |
Features
- Light-guide LED running light
- LED brake light
- Sequential LED turn signal
- LED reverse light
- Black ABS housing, polycarbonate lens
- IP67 sealed, DOT / SAE compliant (per supplier)
Signs you need new tail lights
- Cracked, faded or hazy lens
- Water or condensation inside
- Burned-out bulbs or broken sockets
What's included
- 1 x driver side (left) tail light
- 1 x passenger side (right) tail light
- Connection harness
- All LEDs built in. No extra bulbs needed
Installation: 2004-2008 Ford F-150 Styleside
Tools: Phillips screwdriver or matching driver, plastic trim tool. About 15-20 minutes per side.
- Drop the tailgate. The two lamp screws sit on the inner edge of the tail light, facing the tailgate opening.
- Remove both screws, then pull the lamp straight back to release it from the locating pins on the bedside.
- Twist out the factory bulb sockets (or unplug the lamp connector) and set the old lamp aside.
- Plug the factory connector into the new LED lamp, using the supplied harness where needed. Route the wiring so it is not pinched behind the lamp.
- Seat the lamp on the locating pins, refit the two screws and close the tailgate.
- Test running, brake, turn and reverse on both sides. If the turn signal flashes fast, add a load resistor or LED flasher.
FAQ
What does this fit?
2004-2008 Ford F-150 with the Styleside bed (XL, STX, XLT, FX4, Lariat, King Ranch and similar trims). It does not fit Flareside beds or the 2004 F-150 Heritage (previous-generation body).
Are bulbs included?
Yes. The lamps are fully LED and come with every light source built in, so no extra bulbs are needed.
Does it have a sequential turn signal?
Yes. The red turn section lights in a sequential sweep.
Is this sold as a pair?
Yes: one driver side (left) and one passenger side (right) tail light.
How long does installation take?
About 15-20 minutes per side with basic hand tools.