Chrome Halogen Projector Headlights Pair for Ford Taurus (2013-2014)
$268.95
Skip to product information
Chrome Halogen Projector Headlights Pair for Ford Taurus (2013-2014)
$268.95
DS-GT286603231285
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Replace yellowed, cracked or foggy headlights on your 2013-2014 Ford Taurus with this brand-new pair of halogen projector headlight assemblies with a chrome bezel, HIR2 bulbs included.
Fitment
| Year | Make / Model | Fits |
|---|---|---|
| 2013-2014 | Ford Taurus SE, SEL, Limited (halogen) | Factory halogen headlights |
Will NOT fit: Taurus with factory HID/Xenon or LED; Taurus SHO HID lamps; 2010-2012 Taurus; 2015-2019 Taurus unless your lamp matches.
Common Reasons to Replace
- Yellowed, hazy, or oxidized lenses reducing light output
- Cracked lens or broken mounting tabs
- Moisture or condensation inside the housing
- Collision damage
Specs
- Housing: Gray with chrome bezel
- Lens: Clear
- Low/high beam: HIR2 (9012) (included)
- Side marker: amber
- DOT compliant
- Quantity: Pair (Left + Right)
- Condition: New
Interchange Part Numbers
OEM: . Partslink: .
What's Included
- 1 x Driver side headlight assembly
- 1 x Passenger side headlight assembly
- HIR2 (9012) headlight bulbs installed
Installation
- Open the hood and remove the screws and clips along the top of the front bumper cover.
- Remove the wheel-well screws on each side, release the bumper side clips and pull the cover off the fenders.
- Unplug the headlamp, then remove the upper bolt and front bolt (3.2 Nm / 28 lb-in), the side bolt (7 Nm / 62 lb-in) and the rivet push-pin.
- Pull the lamp out, install the new one in reverse, refit the bumper cover and aim.
Steps compiled from the Ford Taurus service manual (exterior lighting) and FordTaurus.net forum. Professional installation and headlight aiming are recommended.
FAQs
What bulb sizes do these headlights use?
The low/high beam uses an HIR2 (9012) bulb, which is included. The listing does not state the turn/marker bulb sizes; reuse your factory bulbs.
Do I need to remove the front bumper to replace these headlights?
Yes. On the sixth-gen Taurus the front bumper cover has to come off; the lamp is then held by an upper bolt, a front bolt, a side bolt and a push-pin.
How do I change the amber side marker bulb?
Remove the front screws holding the wheel-well splash shield, peel it back and reach up behind the lamp; removing the wheel gives more room.
Can I install HID or LED kits?
Yes. These are halogen projectors, so a 9012 (HIR2) LED or HID kit fits. Aim afterward.