Chrome LED Headlights Pair w/o AFS for BMW 3 Series F30 (2016-2019)

Chrome LED Headlights Pair w/o AFS for BMW 3 Series F30 (2016-2019)

$534.95
Skip to product information
Chrome LED Headlights Pair w/o AFS for BMW 3 Series F30 (2016-2019)

Chrome LED Headlights Pair w/o AFS for BMW 3 Series F30 (2016-2019)

$534.95
DS-63117419630

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Replace hazy or damaged factory LED headlights on your 2016-2019 BMW 3 Series F30 sedan without AFS (adaptive headlights) with this new chrome reflector-type pair. LED modules not included.

Fitment

Year Make / Model Fits
2016-2019 BMW 3 Series F30 sedan (320i, 330i, 340i) with factory LED headlights without AFS, 8-pin US connector Factory LED headlights

Will NOT fit: Cars with AFS (adaptive) headlights or a 6-pin connector; halogen or xenon F30; 2012-2015 pre-LCI.

Common Reasons to Replace

  • Yellowed, hazy, or oxidized lenses reducing light output
  • Cracked lens or broken mounting tabs
  • Moisture or condensation inside the housing
  • Collision damage

Specs

  • Low/high beam, DRL, turn: built-in LED
  • Type: LED reflector, without AFS
  • Connector: 8-pin (US version)
  • Housing: Chrome
  • LED modules: NOT included (per listing)
  • DOT compliant
  • Quantity: Pair (Left + Right)
  • Condition: New

Interchange Part Numbers

OEM: 63117419630. Partslink: BM2503187, BM2502187.

What's Included

  • 1 x Driver side headlight assembly
  • 1 x Passenger side headlight assembly
  • Left and right headlights

Installation

  1. Disconnect the battery. Remove the front rubber hood seal and the 8 Torx screws along the top of the bumper cover.
  2. Remove the screws and plastic rivets underneath, then the three hex screws at each wheel-housing trim and the screws on top of each wheel housing.
  3. Pull the bumper cover forward, unplug its connectors and set it aside (turning or removing the wheels makes access easier).
  4. Remove the screw on the retaining clip at the top rear of the headlight if fitted, open the wheel-well access cover and unplug the 8-pin headlight connector.
  5. Remove the headlight mounting screws (top and lower) and pull the lamp forward out of the car.
  6. Move over any LED driver modules from your old lamps (none are included), install the new lamp, refit the bumper and aim the headlights.

Steps compiled from the BMW Repair Guide F30 bumper and headlight procedures, BMW TIS (via Bimmerfest) and F30 Bimmerpost owner threads. Professional installation and headlight aiming are recommended.

FAQs

Will these fit an F30 with adaptive headlights?
No. The listing says these fit LED headlight cars without AFS only.

How do I check my connector?
The listing photo shows the 8-pin US-version connector matches and the 6-pin does not.

Will I need coding?
Usually not when replacing the same LED non-AFS lamp. If a lamp fault appears, a BMW scan tool can clear it.

Do I need to remove the front bumper to replace these headlights?
Yes. The front bumper cover comes off to reach the headlamp screws.

What bulbs do these use?
None to buy for the headlights. Low and high beams are built-in LED.

Can I install LED or HID kits?
Not applicable. The low and high beams are built-in factory LED; there is no replaceable headlight bulb for an LED or HID kit.

You may also like