Clear and Black LED-Tube Tail Lights Pair for Chevy Impala (2006-2013) / Impala Limited (2014-2016)
$204.95
Skip to product information
Clear and Black LED-Tube Tail Lights Pair for Chevy Impala (2006-2013) / Impala Limited (2014-2016)
$204.95
DS-25971597-LED
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Chevrolet Impala (2006-2013) and Chevrolet Impala Limited (2014-2016) only. They will not fit the redesigned 2014-2016 Impala, which is a different body and uses a different tail light. Compare your current housings with our photos before ordering.
Replace the 9th-generation Impala tails with this clear-lens, black-housing LED-tube pair. You get driver and passenger assemblies with an LED tube for the running and signature lighting, and a halogen reverse section. Reuse your factory reverse bulb — a reverse bulb is not included. The housings use the factory mounting points and factory-style connectors. This is a different design from the red halogen pair we offer for the same years.
Installation for 2006-2013 Impala and 2014-2016 Impala Limited
- Open the trunk and peel back the trunk liner at each rear corner so you can reach the nuts on the housing studs.
- Remove the nuts that hold the assembly to the quarter panel.
- Pull the housing straight back and unplug the factory connector. Transfer the factory reverse bulb if it stays with the harness.
- Seat the new housing on the factory studs, reconnect the factory-style connector, and tighten the nuts.
- Repeat on the other side, then check tail, brake, turn, and reverse functions before putting the liner back.
A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.