Clear and Red Halogen Tail Lights Pair for Ford Explorer (2006-2010)

Give a 2006-2010 Explorer a clean factory-style look with this halogen tail light pair. You get driver and passenger assemblies with a clear and red lens in a black housing. Tail, brake, turn, and reverse functions use your existing halogen bulbs — bulbs are not included, so reuse the factory bulbs if they are still good. The housings use the factory mounting points and factory-style connectors.

Fitment

Specs

• Sold as: a driver and passenger pair
• Style: black housing, clear and red lens
• Lighting: halogen tail, brake, turn, and reverse; bulbs not included
• DOT certified
• 12 V
• New aftermarket assemblies

In the Box

• Driver and passenger clear and red halogen tail lights

Interchange References

Replaces original-style 2006-2010 Explorer tail lights commonly crossed with 6L2Z-13405-CA, 6L2Z-13404-CA, FO2819140, FO2818140, and FO2800195.

Installation: Ford Explorer (2006-2010)

On the 2006-2010 Explorer these tail lights mount at the D-pillars beside the liftgate. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.

1. Open the liftgate. From the cargo opening, locate the nuts on the back of each tail light housing. You may need to peel back a small section of interior cargo trim to reach them.
2. Unplug the factory connector.
3. Remove the retaining nuts and pull the housing straight rearward out of the opening. Do not pry on the lens.
4. Set the new housing into the opening, start the nuts by hand, then tighten them evenly. Plug the factory connector back in until it clicks.
5. Repeat on the other side. Reconnect the battery and check tail, brake, turn, and reverse functions before you drive.