GENSSI hero — clear lens facelift style LED tail lights Nissan GT-R R35 (2009-2017) white background

Clear Lens Facelift Style LED Tail Lights Pair for Nissan GT-R R35 (2009-2017)

$559.95
Skip to product information
GENSSI hero — clear lens facelift style LED tail lights Nissan GT-R R35 (2009-2017) white background

Clear Lens Facelift Style LED Tail Lights Pair for Nissan GT-R R35 (2009-2017)

$559.95
DS-GTR-R35-TAIL-CLR-FACELIFT-LED-2009-2017

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

A dated R35 rear loses to the new facelift look—this all-clear LED ring set gives 2009-2017 GT-Rs the bright white-out lens and red LED ring signature of the 2015+ cars. GENSSI's GT-R kit is a vehicle-specific complete tail light pair that connects to the factory harness without re-wiring.

Fitment

YEAR MAKE / MODEL FITS
2009-2017 Nissan / GT-R R35 Yes

Specs

  • Style: Clear lens facelift-style LED ring design (2015+ look)
  • Bulbs: Built-in LEDs — amber turn signal, white reverse, red LED ring parking and brake. No bulbs required
  • Sold as: Clear lens facelift-style LED tail light pair
  • Fit: Direct-fit clear facelift-style LED tails for 2009-2017 Nissan GT-R R35

Interchange

26555-KB50A, 26550-KB50A

What's included

  • 1x Driver clear facelift LED tail light
  • 1x Passenger clear facelift LED tail light

Installation — Nissan GT-R R35 (2009-2017)

  1. Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
  2. Open the trunk. Pop out the four large trim clips with a trim tool, unscrew the small retaining knob by hand, and lift out the foam organizer tray to expose the body panel behind the lamps.
  3. Using an 8 mm socket, remove the three nuts holding each tail light and the two nuts along the upper edge of the rear bumper; one nut is recessed, so use a deep socket. Disconnect the factory tail light connector.
  4. From underneath, remove the 10 mm and 12 mm bolts on the rear diffuser / undertray, remove the screw and hidden fastener at the wheel-well bumper corner, then pull the bumper corner outward to release its clips and lower it enough to slide the lamp out. Tape the fender and bumper edges first.
  5. Plug the new lamp into the factory harness and the side marker plug, tuck the connectors into the body cavity so the housing sits flush, and slide the lamp into position with the rubber seal flat against the body.
  6. Test parking, brake, turn, and reverse on both sides before reassembly, then refit the bumper corners, diffuser bolts, nuts, foam tray, and trunk trim.

Buyer FAQ

Is this the 2015+ facelift look? Yes. The all white-out clear lens follows the facelift (2015+) design and fits 2009-2017 R35 GT-Rs, so earlier cars get the newer rear signature.

Is this a cheap overlay? No. It is a complete replacement tail light with built-in LEDs: red LED ring for parking and brake, amber turn signal, and white reverse.

Do I splice wiring? No. The assemblies are built for plug-and-play connection to the factory harness with no re-wiring and no error after installation.

You may also like