GENSSI hero — clear lens tail lights 4pc for Acura TSX sedan (2009-2014) on white

Clear Lens Tail Lights 4pc for Acura TSX Sedan (2009-2014)

$179.95
Skip to product information
GENSSI hero — clear lens tail lights 4pc for Acura TSX sedan (2009-2014) on white

Clear Lens Tail Lights 4pc for Acura TSX Sedan (2009-2014)

$179.95
DS-TSX-TAIL-CLR-4PC-2009-2014

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Red factory lenses make a second-generation TSX sedan look dated from a car length back, and this clear four-piece set gives those corners a bright chrome-faced signature while the red brake bulb and amber turn still read at night. GENSSI's kit is a vehicle-specific inner and outer assembly for the 2009-2014 TSX sedan, not a lens cover, and it reuses the factory sockets.

Important Fitment Note: Sedan only. The 2011-2014 TSX Sport Wagon uses a different lamp, and the 2004-2008 TSX does not use this housing. These clear outer lamps have no side-marker socket. Leave the factory side-marker socket unplugged, tape the bulb, and tuck it in the quarter panel so it cannot touch metal.

Fitment

YEAR MAKE / MODEL FITS
2009-2014 Acura / TSX sedan, Base, Special Edition, and V6 Yes
2011-2014 Acura / TSX Sport Wagon No
2004-2008 Acura / TSX No

Specs

  • Style: Chrome housing with a clear lens; polycarbonate lens with UV protection and high impact resistance
  • Bulbs: Incandescent. Bulbs included: 2x 7443 red (brake) and 2x 7440 amber (turn). Sockets are not included. Reuse the factory sockets. The clear 921 reverse bulb is not in the box. The clear outer housing has no side-marker socket
  • Sold as: 4-piece set — inner and outer tail light assemblies, left and right, with bulbs
  • Fit: Direct replacement for the 2009-2014 Acura TSX sedan, including Base, Special Edition, and V6. Factory sockets, no splicing

Interchange

33550-TL0-A01, 33500-TL0-A01, 33550-TL0-A11, 33500-TL0-A11, 34155-TL2-A01, 34150-TL2-A01

What's included

  • 1x Driver outer clear lens tail light
  • 1x Passenger outer clear lens tail light
  • 1x Driver inner clear lens tail light
  • 1x Passenger inner clear lens tail light
  • 2x 7443 red bulbs
  • 2x 7440 amber bulbs

Installation — Acura TSX Sedan (2009-2014)

  1. Open the trunk and pull the side carpet back. The outer lamp brake socket is the gray 7443 twist-lock behind that panel. Pop the clips on the trunk side trim with a plastic trim tool and fold the trim forward.
  2. In the wheel well, remove the Phillips screw that holds the rear bumper cover to the quarter panel. Under that bumper corner, pry out the push clip. Pull the bumper corner back just far enough to reach the lower lamp fastener. Support the cover so it does not drop.
  3. Inside the trunk, remove the 8 mm retainer nuts on the outer lamp studs with an 8 mm socket and a short ratchet. Unplug the brake connector and the turn connector, then pull the outer lamp out. The side-marker socket is the small one at the outer edge. This clear housing has no hole for it. Leave that socket unplugged, tape the bulb, and tuck it in the quarter panel so it cannot ground on the body.
  4. Move the factory sockets that do fit, and lock them a quarter turn clockwise. Push the included red 7443 into the brake socket and the included amber 7440 into the turn socket. The clear 921 reverse bulb is not in the box. Move the original 921 into the reverse socket.
  5. For each trunk-lid lamp, pry the square felt cover off the back of the lid with a trim tool. Remove the three 9 mm screws behind that cover. The fourth 9 mm screw is on the outer edge of the lamp and stays captured in the housing. Back it out until it is free of the lid. If the center trunk garnish overlaps the lamp, release its clips and lift that edge. Do not pry on the lens. Work the lamp out and unplug it.
  6. Line the inner lamp up with the lid opening and press it on before the screws will start. Snug the three 9 mm screws and the captured outer screw, then refit the felt cover. On the outer lamp, start the 8 mm nuts by hand and snug them. Push the bumper corner back onto its clips and replace the wheel-well screw and the under-bumper clip.
  7. Check parking, brake, both turn signals, and reverse. The quarter side marker stays dark on purpose, because that socket is not used on this clear outer housing.

Buyer FAQ

Is this a clear cover or a full tail light? A full four-piece set. Each clear lens is bonded to a chrome housing and replaces the factory inner and outer lamp. It does not sit over the original light.

Where does the side-marker bulb go? Nowhere on the new outer housing. That lamp has no side-marker socket. Unplug the factory side-marker socket, tape the bulb, and tuck it in the quarter panel. Brake, turn, and reverse still use the factory sockets.

Which TSX models fit, and what is in the box? Every 2009-2014 TSX sedan, including Base, Special Edition, and V6. You get two outer housings, two trunk-lid housings, two red 7443 bulbs, and two amber 7440 bulbs. Reuse your sockets and the original clear 921 reverse bulb. It does not fit the 2011-2014 Sport Wagon or the 2004-2008 TSX. Outers replace 33550-TL0-A01 and 33500-TL0-A01 on 2009-2010, and 33550-TL0-A11 and 33500-TL0-A11 on 2011-2014. Trunk-lid lamps replace 34155-TL2-A01 and 34150-TL2-A01.

You may also like