GENSSI hero — facelift style halo LED ring red and clear tail lights Nissan GT-R R35 (2009-2022) white background

Facelift Style Halo LED Ring Red & Clear Tail Lights Pair for Nissan GT-R R35 (2009-2022)

$559.95
Skip to product information
GENSSI hero — facelift style halo LED ring red and clear tail lights Nissan GT-R R35 (2009-2022) white background

Facelift Style Halo LED Ring Red & Clear Tail Lights Pair for Nissan GT-R R35 (2009-2022)

$559.95
DS-GTR-R35-TAIL-HALO-LED-RED-CLR-2009-2022

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Stock R35 tails blend into traffic—this facelift-style halo LED set wraps each round lamp in a glowing red ring that stays unmistakable at night. GENSSI's GT-R kit is a vehicle-specific complete tail light pair that plugs into the factory harness.

Fitment

YEAR MAKE / MODEL FITS
2009-2022 Nissan / GT-R R35 Yes

Specs

  • Style: Red & clear lens, facelift-style halo LED ring design
  • Bulbs: Built-in LEDs — red halo LED rings for parking and brake, amber turn signal, white reverse. No bulbs required
  • Sold as: Facelift-style halo LED ring red & clear tail light pair
  • Fit: Direct-fit facelift-style halo LED tails for 2009-2022 Nissan GT-R R35

Interchange

26555-62B1A, 26550-62B1A

What's included

  • 1x Driver halo LED ring tail light
  • 1x Passenger halo LED ring tail light

Installation — Nissan GT-R R35 (2009-2022)

  1. Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
  2. Open the trunk. Pop out the four large trim clips with a trim tool, unscrew the small retaining knob by hand, and lift out the foam organizer tray to expose the body panel behind the lamps.
  3. Using an 8 mm socket, remove the three nuts holding each tail light and the two nuts along the upper edge of the rear bumper; one nut is recessed, so use a deep socket. Disconnect the factory tail light connector.
  4. From underneath, remove the 10 mm and 12 mm bolts on the rear diffuser / undertray, remove the screw and hidden fastener at the wheel-well bumper corner, then pull the bumper corner outward to release its clips and lower it enough to slide the lamp out. Tape the fender and bumper edges first.
  5. Plug the new lamp into the factory harness and the side marker plug, tuck the connectors into the body cavity so the housing sits flush, and slide the lamp into position with the rubber seal flat against the body.
  6. Test parking, brake, turn, and reverse on both sides before reassembly, then refit the bumper corners, diffuser bolts, nuts, foam tray, and trunk trim.

Buyer FAQ

What does the halo look like? Each round lamp is ringed by a red LED halo with a clear center lens, so the ring glows at night and flares on the brakes.

Is this a bulb swap or a full tail light? A full replacement assembly. The LED rings, amber turn signal, and white reverse are all built in—no bulbs to buy.

Which years fit? 2009-2022 Nissan GT-R R35.

You may also like