Facelift Style Smoke LED Ring Tail Lights Pair for Nissan GT-R R35 (2009-2022)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Stock R35 reds read soft next to a molded-smoke facelift LED ring—this pair puts a sharp blackout LED signature on the GT-R rear. GENSSI's 2009-2022 Nissan GT-R R35 set is a vehicle-specific full LED pair that bolts in and plugs into the factory harness.
Important Fitment Note: Fits 2009-2022 Nissan GT-R R35. Smoke is molded into the lens—not a painted or stick-on tint. Full LED assemblies with facelift-style light-bar / ring signature.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2009-2022 | Nissan / GT-R R35 | Yes |
Specs
- Style: Black housing, molded smoke lens, facelift-style LED light bar / ring
- Bulbs: Full LED — built-in LEDs, no replaceable bulbs
- Sold as: Smoke LED ring tail light pair
- Fit: Direct-fit full LED facelift-style ring tails for R35 GT-R
What's included
- 1x Driver smoke LED ring tail light
- 1x Passenger smoke LED ring tail light
Installation — Nissan GT-R R35 (2009-2022)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the hatch. Remove the rear cargo side trim / access covers to reach the tail light fasteners and connectors.
- If your R35 requires bumper clearance for the outer housings, support the rear bumper cover, release the side clips / fasteners as needed, and ease the cover back just enough for lamp removal.
- Disconnect each harness. Remove the mounting fasteners and carefully pull each factory tail straight back out of the quarter opening.
- Seat the new smoke LED ring assemblies, reconnect plugs, and snug fasteners while checking quarter-panel and bumper gaps.
- Refit any bumper and trim pieces, reconnect the battery, and test tail, brake, turn, and reverse.
Buyer FAQ
Is the smoke just a tint film? No. The smoke is molded into the lens—not painted or stick-on tint overlays.
Are these full assemblies or covers? Full left and right LED tail assemblies with the facelift-style ring / light-bar look—not vinyl covers.
Do I splice wiring? No. After rear access, the assemblies bolt in and the built-in LEDs plug into the factory harness.