Halogen Headlights Pair for Dodge Caliber (2007-2012)

Give a 2007-2012 Caliber a clean factory look again. This original-style halogen pair replaces tired or damaged headlights on the Caliber with clear-lens assemblies and amber reflectors that plug into the factory connectors. Each lamp is DOT and SAE compliant. This is a direct-fit pair — no splicing.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing / style: original-style housing, clear lens, amber reflector
• Lighting: halogen, with bulbs included
• DOT and SAE compliant
• New aftermarket assemblies, designed to replace the factory halogen units

In the Box

• Driver-side headlight assembly
• Passenger-side headlight assembly
• Halogen bulbs

Interchange References

Replaces the original halogen housings used under 5303739AJ (driver) and 5303738AJ (passenger), and Partslink CH2518118 / CH2519118.

Installation: Dodge Caliber (2007-2012)

On the 2007-2012 Caliber, the front bumper cover comes off so you can reach the three headlight bolts. Professional installation and beam aiming are recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.

1. Open the hood. Remove the T25 bolts along the top of the grille, the 7 mm fasteners in the wheel well and at the fender, the clips under the bumper, and the 10 mm bolts under the bumper. Pull the bumper cover forward and set it aside.
2. Remove the three 10 mm bolts on each headlight. Pull the assembly forward. Slide the red lock tab on each connector, press the release, and unplug the harnesses. Do not pull on the wiring.
3. Install the included halogen bulbs in the new housings. Connect the factory-style connectors and slide the red locks back into place. Seat each assembly and start the three 10 mm bolts. Repeat on the other side.
4. Reinstall the bumper cover, clips, and fasteners, reconnect the battery, and test the headlight and turn signal. Aim the lamps on a level surface before driving at night.

Frequently Asked Questions

Which vehicles do these headlights fit?
2007-2012 Dodge Caliber. That is the full production run of the Caliber, and this housing is the original-style halogen lamp used across those years, including after the 2010 facelift. Compare your current lamps with our photos before ordering.

Are these a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Do they include bulbs?
Yes. Halogen bulbs are included for both assemblies.

How are they installed on a 2007-2012 Caliber?
On this generation, the front bumper cover comes off first. Remove the T25 bolts along the top of the grille, the 7 mm fasteners in the wheel well and fender, the under-bumper clips, and the 10 mm bolts under the bumper. Each headlight is then held by three 10 mm bolts. Unplug the harnesses (slide the red lock tab first), install the new lamp with the included bulbs, reconnect, reinstall the bumper, and aim the lamps before nighttime driving.