Halogen Headlights Pair for Toyota Tacoma (1997-2000 2WD and 1998-2000 4WD)

Give a first-generation Tacoma a clean factory look again. This original-style halogen pair replaces tired or hazy headlights on 1997-2000 2WD trucks, including PreRunner, and on 1998-2000 4WD trucks, with clear-lens assemblies that use the factory H4 bulb and the factory connector. Each lamp is DOT and SAE compliant. This is a direct-fit pair — no splicing.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing / style: original-style housing, clear lens
• Lighting: halogen, with H4 bulbs included
• DOT and SAE compliant
• New aftermarket assemblies, designed to replace the factory halogen units

Bulb size: H4 (included).

In the Box

• Driver-side headlight assembly
• Passenger-side headlight assembly
• H4 halogen bulbs

Interchange References

Replaces the original halogen housings used under 8115004090 (driver) and 8111004090 (passenger), and Partslink TO2502120 / TO2503120.

Installation: Toyota Tacoma (1997-2000 2WD and 1998-2000 4WD)

On this Tacoma generation, the parking / signal lamp and the grille come off so you can reach the headlight fasteners. Professional installation and beam aiming are recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.

1. Open the hood. Remove the parking / signal lamp beside the headlight, then remove the grille and set both aside.
2. Remove the 10 mm fasteners at the parking-lamp side of the headlight and the lower inner 10 mm fastener. Pull the assembly forward and unplug the factory connector. Do not pull on the wiring.
3. Install the included H4 bulbs in the new housings. Connect the factory-style connector, seat each assembly, and start the fasteners. Repeat on the other side.
4. Reinstall the grille and parking / signal lamp, reconnect the battery, and test low beam and high beam. Aim the lamps on a level surface before driving at night.

Frequently Asked Questions

Which vehicles do these headlights fit?
1997-2000 Toyota Tacoma 2WD, including PreRunner, and 1998-2000 Tacoma 4WD. They will not fit 1997 4WD Tacoma or 2001-2004 Tacoma, which use different housings. Compare your current lamps with our photos before ordering.

Will they fit a 1997 4WD Tacoma or a 2001-2004 Tacoma?
No. 1997 4WD Tacoma uses a different lamp, and 2001-2004 Tacoma is a later housing. This pair is 1997-2000 2WD (including PreRunner) and 1998-2000 4WD only.

Are these a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Do they include bulbs?
Yes. H4 halogen bulbs are included for both assemblies.

How are they installed on a 1997-2000 Tacoma?
On this generation, the parking / signal lamp and the grille come off first. The headlight is then held by 10 mm fasteners at the parking-lamp side and a lower inner fastener. Unplug the harness, install the new lamp with the included H4 bulbs, reconnect, reinstall the grille and parking lamp, and aim the lamps before nighttime driving.