GENSSI hero — JDM sequential LED tail lights smoke 3rd brake Honda S2000 (2000-2009) white background

JDM Sequential LED Tail Lights + Smoke 3rd Brake for Honda S2000 (2000-2009)

$867.95
Skip to product information
GENSSI hero — JDM sequential LED tail lights smoke 3rd brake Honda S2000 (2000-2009) white background

JDM Sequential LED Tail Lights + Smoke 3rd Brake for Honda S2000 (2000-2009)

$867.95
DS-S2000-TAIL-SEQ-LED-CLR-SMOKE-3RD-2000-2009

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Stock S2000 reds look dated next to a clear sequential LED rear with a smoke center brake—this combo sharpens the AP1/AP2 night signature. GENSSI's 2000-2009 Honda S2000 kit is a vehicle-specific clear LED tail pair plus smoke 3rd brake that bolts in and plugs into the factory harness.

Important Fitment Note: Fits 2000-2009 Honda S2000 AP1/AP2. Kit is clear-lens sequential LED tails plus a smoke-lens LED 3rd brake—not a lens cover set.

Fitment

YEAR MAKE / MODEL FITS
2000-2009 Honda / S2000 AP1/AP2 Yes

Specs

  • Style: Black housing, clear lens LED tails + smoke lens 3rd brake
  • Bulbs: Built-in LEDs — no replaceable bulbs for the LED sections
  • Sold as: Sequential LED tail pair + smoke 3rd brake combo
  • Fit: Direct replacement for S2000 AP1/AP2 — sequential LED turn, built-in LEDs

Interchange

33551-S2A-A01, 33551-S2A-A02, 33551-S2A-A11, 33501-S2A-A01, 33501-S2A-A02, 33501-S2A-A11, 34270S2A003, 34270S2AJ01

What's included

  • 1x Driver sequential LED tail light
  • 1x Passenger sequential LED tail light
  • 1x Smoke LED 3rd brake light

Installation — Honda S2000 AP1/AP2 (2000-2009)

  1. Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
  2. Open the trunk. Pull back the rear carpet / side trim to reach the tail light studs and harness connectors on each quarter panel.
  3. Disconnect each tail harness. Remove the mounting nuts and slide the factory left and right assemblies straight back out of the body openings.
  4. Unbolt the factory center high-mount / 3rd brake from the rear deck / spoiler area, disconnect its connector, and remove it.
  5. Seat the new clear sequential LED tails and smoke 3rd brake, reconnect plugs, and snug fasteners while checking quarter-panel and deck gaps.
  6. Refit the trunk trim, reconnect the battery, and test tail, brake, sequential turn, reverse, and 3rd brake.

Buyer FAQ

Is this just smoked covers? No. You get full left and right sequential LED tail assemblies plus a smoke LED 3rd brake for the S2000.

Do the turns run sequential? Yes. The clear LED tails use a sequential turn-signal pattern on the JDM-style housings.

Do I splice wiring? No. After trunk access, the assemblies bolt in and the built-in LEDs plug into the factory harness.

You may also like