Red Halogen Tail Lights Pair for Chevy S10 / GMC Sonoma (1994-2004) / Isuzu Hombre (1996-2000)
$99.95
Skip to product information
Red Halogen Tail Lights Pair for Chevy S10 / GMC Sonoma (1994-2004) / Isuzu Hombre (1996-2000)
$99.95
DS-5978195
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Chevrolet S10 (1994-2004), GMC Sonoma (1994-2004), and Isuzu Hombre (1996-2000) only. They will not fit Chevrolet Blazer, GMC Jimmy, 1982-1993 S10, or 2004 Colorado. Compare your current housings with our photos before ordering.
Replace faded second-generation S-series tails with this red halogen pair. You get driver and passenger assemblies in a chrome housing with a red lens. Reuse your existing halogen bulbs — bulbs are not included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 1994-2004 | Chevrolet S10 | Pickup only. Red halogen housing. Not Blazer |
| 1994-2004 | GMC Sonoma | Pickup only. Not Jimmy |
| 1996-2000 | Isuzu Hombre | Pickup |
Specs
- Sold as: a driver and passenger pair
- Style: chrome housing, red lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs not included
- DOT certified
- 12 V
- New aftermarket assemblies
- OEM cross-reference: 5978195, 5978196, 15166763, 15166764, GM2800124, GM2801124, GM2800168, GM2801168
What’s in the box
- Driver tail light assembly
- Passenger tail light assembly
Installation
- Open the tailgate so you can reach the screws at the inner edge of each bedside lamp.
- Remove the two screws that hold the assembly to the bedside.
- Pull the housing straight back off the bed, then unplug the factory connector and twist out the bulb sockets.
- Transfer the bulbs and sockets into the new housing, seat it on the factory mounting points, reconnect, and tighten the screws.
- Repeat on the other side, then check tail, brake, turn, and reverse functions before closing the tailgate.
A do-it-yourself installer can usually finish both sides in about 20-30 minutes with a Phillips screwdriver. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.