Red Halogen Tail Lights Pair for Nissan Frontier (2005-2021) / Suzuki Equator (2009-2012)
$99.95
Skip to product information
Red Halogen Tail Lights Pair for Nissan Frontier (2005-2021) / Suzuki Equator (2009-2012)
$99.95
DS-26550EA825
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Nissan Frontier (2005-2021) and Suzuki Equator (2009-2012). They will not fit 2022-up Frontier (a new body) or 1998-2004 Frontier. Compare your current housings with our photos before ordering.
Refresh a 2005-2021 Frontier or a 2009-2012 Equator with this red halogen tail light pair. You get driver and passenger assemblies with a red lens in a chrome housing. Tail, brake, turn, and reverse functions are halogen, and bulbs are included. The housings use the factory mounting points and factory-style connectors. The Equator shares this Frontier platform, so the same pair covers both.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2005-2021 | Nissan Frontier | D40 body. Not 2022-up D41, not 1998-2004 |
| 2009-2012 | Suzuki Equator | Same Frontier-based housing |
Specs
- Sold as: a driver and passenger pair
- Style: chrome housing, red lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs included
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger red halogen tail lights
- Bulbs
Interchange References
Replaces original-style 2005-2021 Frontier and 2009-2012 Equator tail lights commonly crossed with 26550-EA825, 26555-EA825, NI2800206, NI2801206, NI2800170, and NI2801170.
Installation: Nissan Frontier (2005-2021) and Suzuki Equator (2009-2012)
On these trucks the tail lights bolt to the bedside and are reached with the tailgate open. The Equator uses the same arrangement as the Frontier. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the tailgate. From the bed opening, locate the bolts on the face of each tail light housing.
- Remove the bolts and pull the housing straight back out of the bedside. Do not pry on the lens.
- Unplug the factory connector.
- Plug the factory connector into the new housing until it clicks, set the housing into the opening, start the bolts by hand, then tighten them evenly.
- Repeat on the other side. Reconnect the battery and check tail, brake, turn, and reverse functions before you drive.