Smoked Sequential LED Tail Lights Pair for Toyota FJ Cruiser (2007-2014)
$351.95
Skip to product information
Smoked Sequential LED Tail Lights Pair for Toyota FJ Cruiser (2007-2014)
$351.95
DS-PT0248C-S
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Upgrade your 2007-2014 Toyota FJ Cruiser with this black-housing, smoked-lens LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.
Fitment
| Years | Make / Model | Generation |
|---|---|---|
| 2007-2014 | Toyota / FJ Cruiser | XJ10 |
2007-2014 Toyota FJ Cruiser (all US model years). Same lamp also listed for 2015-2020 non-US FJ Cruisers.
Features
- Light-guide LED running light with start-up animation
- LED brake light
- Dynamic sequential LED turn signal
- LED reverse light
- Black ABS housing, smoked polycarbonate lens
- IP67 sealed, DOT / SAE compliant (per supplier)
Signs you need new tail lights
- Cracked, faded or hazy lens
- Water or condensation inside
- Dead LED sections or broken sockets
What's included
- 1 x driver side (left) tail light
- 1 x passenger side (right) tail light
- Connection harness
- All LEDs built in. No extra bulbs needed
Installation: 2007-2014 Toyota FJ Cruiser (XJ10)
Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 15-20 minutes per side.
- Open the rear door. Each tail light is held by two screws on its inner edge, visible in the rear door opening.
- Remove the two screws, then pull the lamp straight back to release its outer clips from the body.
- Unplug the factory connector and set the old lamp aside.
- Connect the new lamp (supplied harness where included), routing the wire so it is not pinched.
- Align the lamp on its clips, press it home and refit the fasteners.
- Test running, brake, turn and reverse on both sides.
- If the turn signal flashes fast, add a load resistor or LED flasher.
FAQ
What does this fit?
2007-2014 Toyota FJ Cruiser (all US model years). Same lamp also listed for 2015-2020 non-US FJ Cruisers.
Are bulbs included?
Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.
Does it have a sequential turn signal?
Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.
Is this sold as a pair?
Yes: driver side (left) and passenger side (right).
How long does installation take?
About 15-20 minutes per side with basic hand tools.