Xenon HID Ballast 1307329153 D1S for BMW, Mini, Audi TT, Cadillac DTS (2006-2016)

New D1S xenon HID headlight ballast, a direct replacement for Bosch 1307329153 (BMW 63117182520), for BMW E92/E93 3 Series and M3, E63/E64 6 Series, X3, X5, Mini Cooper, Audi TT, Cadillac DTS and 2014-2016 Jeep Cherokee with factory xenon headlights. Replacement unit for Bosch-type ballasts, not a Genuine Bosch or BMW part. Free shipping to the lower 48.

Fix a Dark or Flickering Xenon Headlight

This ballast powers the factory D1S xenon headlight. When it fails the headlight can go dark, flicker or cut out. Replacing the ballast costs far less than a complete headlamp.

Fits

Fits vehicles with the factory Xenon headlamp. Match the part number on your old module before ordering.

OEM / Interchange Part Numbers

• Bosch 1307329153 / 1 307 329 153 01 / 130732915301
• Bosch 1307329193 / 130732919301
• BMW / Mini 63117182520 (7182520)
• BMW / Mini 63112754797
• Audi 8J0907391
• Cadillac / GM 25806714
• 5952706 / 2901597

Common Signs of a Failed Module

• Headlight goes out after a few seconds or minutes
• Headlight flickers or cycles on and off
• One headlight dead while the bulb is good
• Headlight color shifts or the lamp won't strike

Specs

• Brand: replacement for Bosch (not Genuine OEM)
• Lighting technology: Xenon HID, D1S / D1R bulb
• Placement: front left or right headlight
• Sold as one unit, new
• Warranty: 2 years

What's Included

• 1 x xenon HID ballast 1307329153 (replacement, no bulb)

Installation

1. Turn the headlights and ignition off and disconnect the negative battery cable. Let the bulb and ballast cool.
2. On the BMW / Mini / Audi / Cadillac the ballast is mounted to the bottom or back of the headlamp housing. Depending on the vehicle you may reach it through the wheel-well liner, or you may need to loosen the bumper cover and unbolt the headlamp to pull it forward.
3. Unplug the main power connector and the igniter/bulb lead, then remove the screws holding the ballast to the housing.
4. Compare the part number on your old ballast to the numbers above before fitting the new one.
5. Fit the new ballast, refit its screws and lock every connector fully. It is a direct replacement; no wiring modification is needed when the connectors match.
6. Reinstall the headlamp and trim, reconnect the battery and test low beam (and high beam if bi-xenon).

FAQ

Is this a Genuine Bosch or BMW part?
No. It is a new replacement built to fit in place of Bosch 1307329153 / BMW 63117182520 ballasts.

Which bulb does it use?
It is for D1S / D1R xenon bulbs. The bulb is not included.

Is shipping free?
Yes, shipping is free to the lower 48 US states.