Black Full LED Headlights Pair with LED DRL for Toyota Tacoma Limited / TRD Off-Road / TRD Sport (2020-2023)

Replace faded or cracked factory LED lamps on your 2020-2023 Limited or TRD Tacoma with this OE-style pair. Each black housing has the full LED low and high beam and the signature LED daytime running light, and it bolts to the factory points and plugs into the factory connectors, with no splicing.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing: black, clear lens, amber corner
• Low and high beam: full LED; daytime running light: LED, built in
• LED bulbs, 6-pin plugs, sockets, ballast, resistors, LED control module, circuit board and access cover included, already installed
• DOT and SAE compliant
• Plugs into the factory connectors (no splicing)

In the Box

• Driver-side full LED headlight with LED DRL
• Passenger-side full LED headlight with LED DRL
• 6-pin plugs, bulbs, sockets, ballast, resistors, LED control module, circuit board, connector plate and access cover (already installed)

Interchange References

Replaces the original assemblies commonly crossed with 81150-04290, 81110-04290, TO2502291, TO2503291.

Installation: Toyota Tacoma Limited / TRD Off-Road / TRD Sport (2020-2023)

On the 2020-2023 Tacoma the grille comes off first, and the bumper cover is loosened at the corners so you can reach the lower headlight bolt. Turn the lights and ignition off before you start. If your truck has the safety-sensor connector in the grille, unplug it before you lift the grille off.

1. Open the hood. Remove the 10 mm bolts across the top of the grille and the push clips beside the headlights. Unplug the grille-mounted sensor connector if equipped, then lift the grille off.
2. Remove the clips and the 10 mm bolt that free the bumper corner under the lamp so you can reach the lower headlight bolt.
3. Remove the two 10 mm bolts on top of the headlight and the lower 10 mm bolt. Slide the lamp toward the grille to release the rear tab, pull it forward and unplug the connectors.
4. Plug the new lamp in, seat the rear tab and locating points, and start all bolts by hand before tightening them evenly.
5. Refit the bumper corner, grille and sensor connector, test low beam, high beam, LED DRL and turn signal, then aim the beams.

Frequently Asked Questions

Which vehicles do these headlights fit?
2020-2023 Toyota Tacoma Limited, TRD Off-Road and TRD Sport with factory full LED headlights. They do not fit halogen trucks, the TRD Pro, or 2016-2019 and 2024+ Tacomas. Compare your current lamps with our photos before ordering.

Is this a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Will these fit a Tacoma with halogen headlights?
No. They only fit trucks that came with factory full LED headlights. Halogen 2016-2022 lamps are a different part.

Will these fit a TRD Pro?
No. TRD Pro trucks are excluded.

Are bulbs included?
Yes. The LED bulbs, 6-pin plugs, control module and ballast come already installed.

Do I need to cut or splice any wiring?
No. Each lamp plugs into the factory connectors.

How are they installed on a 2020-2023 Toyota Tacoma Limited / TRD?
Remove the grille (and unplug the grille sensor if equipped), loosen the bumper corner, take out the three 10 mm headlight bolts, unplug the lamp and install the new one. Aim the beams afterward.