Black Full LED Projector Headlights Pair with LED DRL for Nissan Altima S / SV / SR / SL (2023-2025)

Replace faded or cracked factory LED lamps on your 2023-2025 Altima S, SV, SR or SL with this OE-style pair. Each black housing has the LED projector low and high beam and the signature LED daytime running light, and it bolts to the factory points and plugs into the factory connectors, with no splicing. These are sealed LED assemblies — there is no replaceable bulb.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing: black, clear lens, amber side marker
• Low and high beam: LED projector, built in; daytime running light: LED, built in
• Factory sealed LED — no replaceable bulb
• Plugs into the factory connectors (no splicing)

In the Box

• Driver-side full LED projector headlight
• Passenger-side full LED projector headlight

Interchange References

Replaces the original assemblies commonly crossed with 26060-9HF0C, 26010-9HF0C, 26060-9HF0D, 26010-9HF0D, NI2502295, NI2503295.

Installation: Nissan Altima S / SV / SR / SL (2023-2025)

On the 2023-2025 Altima the front bumper cover comes off so you can reach the headlight bolts. Work with a helper and a shop manual for your year and trim. Turn the lights and ignition off before you start, disconnect the negative battery cable, and wait a few minutes before unplugging the lamp.

1. Open the hood. Remove the clips and fasteners along the top of the bumper cover and grille.
2. Remove the fasteners in each front wheel liner and along the lower edge of the bumper, plus the bolts at the fender corners. Unplug any bumper or sensor connectors as equipped, then ease the cover forward and set it aside.
3. Unplug the headlight connector, remove the mounting bolts, and lift the lamp out.
4. Set the new lamp in place, start all bolts by hand, tighten them evenly, and reconnect the factory plug.
5. Refit the bumper cover and any connectors, reconnect the battery, and test low beam, high beam, daytime running light and turn signal before you drive. Aim the beams after installation.

Frequently Asked Questions

Which vehicles do these headlights fit?
2023-2025 Nissan Altima S, SV, SR and SL (L34 facelift) with factory full LED projector headlights, including 2.5L and 2.0L. They do not fit the 2019-2022 Altima. Compare your current lamps with our photos before ordering.

Is this a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Will these fit a 2019-2022 Altima?
No. The 2019-2022 Altima is a different lamp. We carry the 2019-2022 full LED pair and the 2019-2022 halogen pair for the S.

Are bulbs included?
These are factory-style sealed LED projectors. There is no replaceable bulb; the LED low beam, high beam and daytime running light are built into each lamp.

Do I need to cut or splice any wiring?
No. Each lamp plugs into the factory connectors.

How are they installed on a 2023-2025 Nissan Altima S / SV / SR / SL?
The front bumper cover comes off so you can reach the headlight bolts. Unplug any bumper or sensor connectors as equipped, unplug and unbolt the lamp, install the new one, refit the cover, reconnect the battery, test the lights, and aim the beams afterward.