Black Halogen Headlights Pair for Chevy Tahoe Suburban (2007-2014) & Avalanche (2007-2013)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
New black halogen headlights, sold as a driver-side and passenger-side pair for the 2007-2014 Chevrolet Tahoe and Suburban, 2007-2013 Avalanche application listed below.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2007-2014 | Chevrolet Suburban 1500 | See fitment warning |
| 2007-2014 | Chevrolet Tahoe | See fitment warning |
| 2007-2013 | Chevrolet Avalanche | See fitment warning |
| 2007-2013 | Chevrolet Suburban 2500 | See fitment warning |
Specs
- Condition: New
- Sold as: Left and right pair
- Style: Black
- Lighting type: Halogen
- Bulb application: H11 low beam; 9005 high beam; 3157 signal
- Bulbs not included
In the Box
- 1 driver-side headlight assembly
- 1 passenger-side headlight assembly
Interchange References
GM2503263, GM2502263, 22853025, 22853026, 20760578, 20760579
Installation: 2007-2014 Chevrolet Tahoe and Suburban, 2007-2013 Avalanche
Professional installation and beam aiming are recommended.
- Open the hood and remove the two 10 mm bolts on top of the headlight. Protect the bumper paint with tape, then remove the 7 mm inner-fender screws and push pins and pull the splash shield back.
- Loosen the rear 10 mm bolt behind the lamp, release the bumper clips and pull the headlight forward. Disconnect its electrical connector.
- Fit compatible H11 low-beam, 9005 high-beam and 3157-type signal bulbs. Connect the harness, align the locating tabs, reinstall the rear and top bolts and refit the splash shield. Test and aim the lamps (adjusters take a 5 mm Allen key).
Frequently Asked Questions
What should I check before ordering?
Fits 2007-2014 Chevrolet Tahoe and Suburban 1500, 2007-2013 Suburban 2500 and 2007-2013 Avalanche. Bulbs are not included.
Are bulbs included?
No. This package contains the headlight assemblies only; bulbs are not included.
What access is needed to replace the assemblies?
Open the hood and remove the two 10 mm bolts on top of the headlight. Protect the bumper paint with tape, then remove the 7 mm inner-fender screws and push pins and pull the splash shield back.