Black Halogen Headlights Pair for Dodge Charger (2011-2014)

New black-housing halogen headlight pair for the 2011-2014 Dodge Charger, built to the factory shape for halogen-equipped cars. H11 low, 9005 high, 3157 turn signal. Bulbs are not included.

Fitment

Will NOT fit: Chargers with factory HID headlights, 2006-2010 or 2015+ Chargers.

Common Reasons to Replace

• Yellowed, hazy, or cracked factory lenses cutting light output
• Moisture or condensation inside the housing
• Broken mounting tabs or collision damage
• Refreshing the front end with a new black look

Specs

• Light type: Halogen (H11 low + 9005 high)
• Housing: Black, clear lens
• Bulbs: Low beam H11, high beam 9005, turn signal 3157, side marker T10 (bulbs NOT included)
• Lens: Polycarbonate; housing: polypropylene
• DOT & SAE compliant
• Fitment type: Direct replacement, plug-and-play connectors
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: 57010410AE, 57010410AF, 57010411AE, 57010411AF · Partslink: CH2502232, CH2503232

What's Included

• 1 x Driver-side headlight assembly
• 1 x Passenger-side headlight assembly
• Bulbs not included — fits Low beam H11, high beam 9005, turn signal 3157, side marker T10

Installation (2011-2014 Dodge Charger)

Tools: 10 mm socket and ratchet, T25/T30 Torx, trim/push-pin tool.

1. Disconnect the negative battery cable.
2. Remove the radiator closure panel push pins and the fascia fasteners along the top.
3. Remove the wheel-well liner fasteners at the front of each fender and the lower fascia/belly pan fasteners.
4. Unplug the fog lights and pull the front fascia off.
5. Remove the headlight mounting bolts and pull the lamp forward.
6. Unplug the connector and move the H11, 9005, 3157 and T10 bulbs.
7. Install the new lamp, reconnect, test, refit the fascia and aim the beams.

Steps based on the 2011-2014 Dodge Charger (LD) factory service manual fascia and headlamp procedures.

FAQ

Will these work on a Charger with factory HID?
No. HID cars use a different housing, ballast and wiring. This pair is for halogen-equipped Chargers.

Do I have to remove the front fascia?
Yes. The factory procedure removes the front fascia to reach the headlamp mounting bolts.

What bulb sizes do these use?
Low beam H11, high beam 9005, turn signal 3157, side marker T10 (bulbs NOT included).

Can I put LED bulbs in these?
Yes. These are halogen housings, so H11/9005 LED conversion kits fit. Use a quality kit with a CANbus decoder if you see flicker or a bulb-out warning, and re-aim the beams after install.