Black Halogen Headlights Pair for Ford Flex (2013-2019)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Replace faded or cracked factory halogen lamps on your 2013-2019 Ford Flex with this black-housing pair. Each lamp uses halogen high and low beams, includes the bulbs, bolts to the factory points, and plugs into the factory connectors, with no splicing.
Important Fitment Note: Fits 2013-2019 Ford Flex factory halogen headlights only. Not for HID or aftermarket projector housings.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2013-2019 | Ford Flex | Factory halogen only. Not HID or aftermarket projector housings. |
Specs
- Sold as: driver and passenger pair (two lamps)
- Housing: black with chrome trim, clear lens
- High and low beam: halogen, H13 bulbs included
- Turn signal: 3157NA bulbs included
- DOT and SAE compliant
- Plugs into the factory connectors (no splicing)
Interchange
Replaces / cross-references: DA8Z13008C, DA8Z13008A, FO2502312, FO2503312
What's included
- 1x driver side (left) halogen headlight (DA8Z13008C)
- 1x passenger side (right) halogen headlight (DA8Z13008A)
- H13 high/low bulbs (installed)
- 3157NA turn-signal bulbs (installed)
Installation — 2013-2019 Ford Flex
Tools: socket set, screwdriver, plastic trim tool. Estimated time: about 45 to 90 minutes.
- Park on level ground, open the hood, turn the lights and ignition off, and disconnect the negative battery cable.
- Remove the upper radiator sight shield so you can reach the headlight bolts along the top of each housing.
- Unplug the factory connectors from the back of the lamp.
- Remove the mounting bolts at the top of the housing and at the inner fender. If a lower fastener is blocked by the fascia, loosen that bumper corner just enough to reach it — a full bumper-cover removal is usually not required on the 2013-2019 Flex.
- Ease the lamp forward and out. Transfer any retained brackets to the new lamp if present.
- Set the new lamp in place, install the bolts, and reconnect the connectors. Repeat on the other side.
- Refit the sight shield, reconnect the battery, test high beam, low beam, and turn signals, then aim the beams on a level surface.
Buyer FAQ
Will these fit a Ford Flex with factory HID or aftermarket projector lamps? No. These fit 2013-2019 Ford Flex models with factory halogen headlights only. Compare your current lamps with the photos before ordering.
Are bulbs included? Yes. Each lamp includes the H13 high/low beam and 3157NA turn-signal bulbs.
Do these headlights plug into the factory connectors? Yes. They bolt to the factory points and plug into the factory connectors, with no splicing. Replaces DA8Z13008C, DA8Z13008A, FO2502312, and FO2503312.