Black Projector Halogen Headlights Pair for Toyota RAV4 (2013-2015)

Give your fourth-generation RAV4 a sharp, clean face again. This black-housing projector pair replaces hazy, yellowed or cracked 2013-2015 headlights with crisp clear lenses, a chrome-ringed projector low beam and the factory amber corner. Each lamp bolts to the original mounting points and plugs into the factory connectors, with no splicing.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing: black, clear lens, amber corner reflector
• Low beam: halogen projector
• Lighting: halogen; bulbs and sockets not included (reuse your factory bulbs)
• Mounts to the factory points and plugs into the factory connectors (no splicing)
• New aftermarket assemblies built to the original shape

In the Box

• Driver-side projector headlight assembly
• Passenger-side projector headlight assembly

Installation: Toyota RAV4 (2013-2015)

On the 2013-2015 RAV4 the headlight mounting bolts sit behind the front bumper cover, so the cover has to come off. Plan on about an hour per side if you have not done it before, and get a helper to support the bumper. Turn off the lights and ignition and disconnect the negative battery cable before you start.

1. Remove the fasteners along the top edge of the bumper cover, then the screws and clips in each front wheel well and along the underside.
2. Release both bumper corners from the fender brackets and pull the cover forward. Unplug any fog light connectors and set the cover on a soft surface.
3. Remove the headlight mounting bolts, slide the housing forward and release the connector locks and harness clips. Twist out the bulb sockets.
4. Move your bulbs and sockets to the new lamp, clip the harness on, seat the locating pin and lower bracket, then start and snug the bolts. Do not force the housing past a misaligned pin.
5. Refit the bumper cover, aligning the side clips before you install the upper and lower fasteners. Reconnect the battery, test every function and aim the beams.

Frequently Asked Questions

Which vehicles do these headlights fit?
2013-2015 Toyota RAV4 LE, XLE, Limited and Limited Platinum with the 2.5L engine. They do not fit 2016-2018, 2009-2012, or the RAV4 EV. Compare your current lamps with our photos before ordering.

Is this a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Do these come with bulbs?
No. Bulbs and sockets are not included. Move your factory bulbs and sockets over to the new lamps or buy new ones.

Do I need to cut or splice any wiring?
No. Each lamp plugs into the factory connectors.

How are they installed on a 2013-2015 Toyota RAV4?
The bumper cover has to come off. Remove the top, wheel-well and lower fasteners, pull the cover forward, then unbolt the headlight, move your bulbs over, and bolt in the new lamp. Aim the beams when you are done.