Black Sequential LED Tail Lights Pair for Ford F-150 Styleside (2004-2008)

Black Sequential LED Tail Lights Pair for Ford F-150 Styleside (2004-2008)

$339.95
Ir directamente a la información del producto
Black Sequential LED Tail Lights Pair for Ford F-150 Styleside (2004-2008)

Black Sequential LED Tail Lights Pair for Ford F-150 Styleside (2004-2008)

$339.95
DS-PT0038A-S

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Give your 2004-2008 Ford F-150 Styleside a modern rear end with this black-housing LED tail light pair. A full light-guide running lamp, bright LED brake section, sequential turn signal and clear LED reverse light replace the factory bulb-type lamps, bolting into the original mounting points.

Fitment

Year Make / Model Fits
2004-2008 Ford / F-150 Styleside bed only; not Flareside; not 2004 F-150 Heritage

Features

  • Light-guide LED running light
  • LED brake light
  • Sequential LED turn signal
  • LED reverse light
  • Black ABS housing, polycarbonate lens
  • IP67 sealed, DOT / SAE compliant (per supplier)

Signs you need new tail lights

  • Cracked, faded or hazy lens
  • Water or condensation inside
  • Burned-out bulbs or broken sockets

What's included

  • 1 x driver side (left) tail light
  • 1 x passenger side (right) tail light
  • Connection harness
  • All LEDs built in. No extra bulbs needed

Installation: 2004-2008 Ford F-150 Styleside

Tools: Phillips screwdriver or matching driver, plastic trim tool. About 15-20 minutes per side.

  1. Drop the tailgate. The two lamp screws sit on the inner edge of the tail light, facing the tailgate opening.
  2. Remove both screws, then pull the lamp straight back to release it from the locating pins on the bedside.
  3. Twist out the factory bulb sockets (or unplug the lamp connector) and set the old lamp aside.
  4. Plug the factory connector into the new LED lamp, using the supplied harness where needed. Route the wiring so it is not pinched behind the lamp.
  5. Seat the lamp on the locating pins, refit the two screws and close the tailgate.
  6. Test running, brake, turn and reverse on both sides. If the turn signal flashes fast, add a load resistor or LED flasher.

FAQ

What does this fit?

2004-2008 Ford F-150 with the Styleside bed (XL, STX, XLT, FX4, Lariat, King Ranch and similar trims). It does not fit Flareside beds or the 2004 F-150 Heritage (previous-generation body).

Are bulbs included?

Yes. The lamps are fully LED and come with every light source built in, so no extra bulbs are needed.

Does it have a sequential turn signal?

Yes. The red turn section lights in a sequential sweep.

Is this sold as a pair?

Yes: one driver side (left) and one passenger side (right) tail light.

How long does installation take?

About 15-20 minutes per side with basic hand tools.

También te puede interesar