Chrome Halogen Headlights Pair for Ford Crown Victoria (1998-2011)

Replace your Ford Crown Victoria front lamps with a new driver and passenger pair in chrome finish, with clear/smoked corner lenses (not amber).

Fitment

Specs

• Sold as: driver and passenger pair; corner/signal lamps also included
• Housing/style: Chrome
• Corner/signal lenses: clear/smoked (not amber)
• Lighting: Halogen
• High/low beam: 9007; corner/signal: 3457A.
• Headlight bulbs not included

Bulb sizes: 9007 | 3457A

In the Box

• Driver-side headlight assembly
• Passenger-side headlight assembly
• Driver-side corner/signal lamp
• Passenger-side corner/signal lamp

Interchange References

4W7Z13008B, 4W7Z13008A, XW7Z15A201AA, XW7Z15A201AB, FO2503200, FO2521147

Installation: 1998-2011 Ford Crown Victoria

Professional installation and beam aiming are recommended. Switch off the ignition and lights before servicing.

1. Open the hood and release the three twist-type clips on the upper close-out panel above the lamps, then lift the panel back for access. No bumper removal is needed on this body style.
2. Pry up the two retaining tabs that anchor each headlight, then draw the headlight and corner lamp forward. Unplug the 9007 headlamp bulb connector and twist out the 3457A-type corner/signal socket.
3. Before fitting the new set, match the adjuster screw positions to the old housings for a preliminary aim. Install compatible bulbs, route the sockets straight back, seat the housing and push both tabs fully down. Refit the close-out panel clips, test all functions and fine-tune the aim.

Frequently Asked Questions

Which vehicles do these headlights fit?
Fits 1998-2011 Ford Crown Victoria. Not compatible with Police Interceptor models equipped with strobe-light corner lamps. Bulbs are not included.

Which bulbs do these assemblies use?
High/low beam: 9007; corner/signal: 3457A. Headlight bulbs are not included; transfer compatible serviceable bulbs or buy replacements separately.

What access is needed for installation?
The upper close-out panel and headlamp retaining tabs provide access; bumper removal is not required. Professional installation and beam aiming are recommended.