Chrome Halogen Headlights Pair for Toyota RAV4 (2004-2005)

New chrome-housing halogen headlight pair for the facelifted 2004-2005 Toyota RAV4, with the round amber turn signal corner of the factory lamp. Single H4 dual-filament reflector (low + high). Bulbs are not included.

Fitment

Will NOT fit: 2001-2003 RAV4 (different lamp), or the 2006+ third-generation RAV4.

Common Reasons to Replace

• Yellowed, hazy, or cracked factory lenses cutting light output
• Moisture or condensation inside the housing
• Broken mounting tabs or collision damage
• Refreshing the front end with a new chrome look

Specs

• Light type: Halogen reflector (single H4 low/high)
• Housing: Chrome, clear lens, amber turn signal
• Bulbs: Headlight (low/high) H4, turn signal 7440 (bulbs NOT included)
• Lens: Polycarbonate; housing: polypropylene
• DOT & SAE compliant
• Fitment type: Direct replacement, plug-and-play connectors
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: 81105-42280, 81106-42280 · Partslink: TO2518103, TO2519103

What's Included

• 1 x Driver-side headlight assembly
• 1 x Passenger-side headlight assembly
• Bulbs not included — fits Headlight (low/high) H4, turn signal 7440

Installation (2004-2005 Toyota RAV4)

Tools: 10 mm socket and ratchet, Phillips screwdriver, flat trim tool, pliers, masking tape.

1. Disconnect the negative battery cable.
2. Remove the grille: 2 large screws at the outer corners, 3 small screws near the hood latch, then squeeze the 3 lower clips and pull it out.
3. Remove the grille brace/upper panel (screws and plastic clips) and release its side clips from the fenders — tape the fender edges first.
4. Remove the bumper cover: the bolt in each wheel well (one hides behind the liner), the screws at the lower edges, and the 4–6 bolts under the front lip.
5. Pull the bumper cover forward and set it aside.
6. Remove the 3 headlight fasteners (2 on top, 1 on the fender side), release the tab, and pull the lamp out.
7. Unplug the H4 connector and twist out the 7440 turn signal socket. Move the bulbs to the new lamp.
8. Install the new lamp, reconnect, and test before refitting the bumper, brace and grille. Aim the beams.

Steps based on the Toyota RAV4 repair manual (LI-93) and RAV4World owner write-ups.

FAQ

Can I change the headlights without removing the bumper?
RAV4World owners say no — they tried tilting the lamps out and could not. The bumper cover and grille brace have to come off for the lamp to clear.

Will these fit a 2003 RAV4?
No. The 2004-2005 facelift lamp has a different shape and amber corner. This pair is for 2004-2005 only.

What bulb sizes do these use?
Headlight (low/high) H4, turn signal 7440 (bulbs NOT included).

Can I put LED bulbs in these?
Yes. These are halogen housings, so H4 LED conversion kits fit. Use a quality kit with a CANbus decoder if you see flicker or a bulb-out warning, and re-aim the beams after install.