Clear and Black Sequential LED Tail Lights Pair for Ford Mustang (1999-2004)
$178.95
Ir directamente a la información del producto
Clear and Black Sequential LED Tail Lights Pair for Ford Mustang (1999-2004)
$178.95
DS-FO2818109-LED
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Ford Mustang (1999-2004) only. They will not fit Cobra models, which use a different housing, and they will not fit 2005-up Mustang. Compare your current lamps with our photos before ordering.
Replace the 1999-2004 Mustang tails with this clear-lens, black-housing sequential LED pair. You get driver and passenger assemblies with LED tail, brake, turn, and reverse lighting and a sequential turn signature. Load resistors are included in the box. The housings use the factory mounting points and factory-style connectors. This is a different design from the all-clear halogen pair we offer for the same years.
Installation for 1999-2004 Ford Mustang
- Open the trunk and peel back the trunk liner at each rear corner so you can reach the nuts on the housing studs.
- Remove the nuts that hold the assembly to the quarter panel.
- Pull the housing straight back and unplug the factory connector.
- Plug the new housing into the factory-style connector. Install the included load resistors as shown in the instructions if the turn signal hyper-flashes, then seat the housing on the studs and tighten the nuts.
- Repeat on the other side, then check tail, brake, sequential turn, and reverse functions before putting the liner back.
A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.