Clear and Red Halogen Tail Lights Pair for Toyota Tacoma (1995-2000)
$99.95
Ir directamente a la información del producto
Clear and Red Halogen Tail Lights Pair for Toyota Tacoma (1995-2000)
$99.95
DS-8155004030
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Toyota Tacoma (1995-2000) only. They will not fit 2001-2004 Tacoma (a different three-lens housing) or 2005-up Tacoma. Compare your current housings with our photos before ordering.
Replace faded 1995-2000 Tacoma tails with this clear and red halogen pair. Each housing has a clear upper section for the turn and reverse lamps and a red lower section for the tail and brake lamp. 1016 and 1141 bulbs are included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 1995-2000 | Toyota Tacoma | Clear upper / red lower halogen housing. Not 2001-up |
Specs
- Sold as: a driver and passenger pair
- Style: clear upper lens, red lower lens
- Lighting: halogen tail, brake, turn, and reverse; 1016 and 1141 bulbs included
- DOT certified
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger clear and red halogen tail lights
- 1016 and 1141 bulbs
Interchange References
Replaces original-style 1995-2000 Tacoma tail lights commonly crossed with 81550-04030 and 81560-04030.
Installation: Toyota Tacoma (1995-2000)
On first-generation Tacoma these tail lights mount to the bedside, with the fasteners reached from inside the bed or behind the housing. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the tailgate. From inside the bed, locate the tail light fasteners on the back of the housing.
- Unplug the factory connector.
- Remove the retaining screws or nuts and pull the housing straight out of the bedside. Do not pry on the lens.
- Set the new housing into the opening, start the fasteners by hand, then tighten them evenly. Plug the factory connector back in until it clicks.
- Repeat on the other side. Reconnect the battery and check tail, brake, turn, and reverse functions before you drive.