Clear Halogen Tail Lights Pair for Ford Mustang (1999-2004)
$113.95
Ir directamente a la información del producto
Clear Halogen Tail Lights Pair for Ford Mustang (1999-2004)
$113.95
DS-3R3Z13405AA
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Ford Mustang (1999-2004) V6 and GT models that use this all-clear four-section halogen housing. They will not fit Cobra, 1994-1998 Mustang, or 2005-up Mustang. Compare your current housings with our photos before ordering.
Give a 1999-2004 Mustang a clean all-clear look with this halogen tail light pair. You get driver and passenger assemblies with a clear lens and black housing. Tail, brake, turn, and reverse functions use your existing halogen bulbs — bulbs are not included, so reuse the factory bulbs if they are still good.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 1999-2004 | Ford Mustang | V6 and GT; all-clear halogen housing. Not Cobra |
Specs
- Sold as: a driver and passenger pair
- Style: black housing, clear lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs not included
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger clear halogen tail lights
Interchange References
Replaces original-style 1999-2004 Mustang tail lights commonly crossed with 3R3Z-13405-AA and 3R3Z-13404-AA.
Installation: Ford Mustang (1999-2004)
On the New Edge Mustang these tail lights bolt to the rear quarter, with the nuts reached from inside the trunk. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the trunk and fold back the side trunk liner enough to reach the tail light nuts on that side.
- Unplug the factory connector from the back of the housing.
- Remove the retaining nuts, then pull the housing straight back out of the quarter panel. Do not pry on the lens.
- Transfer your existing halogen bulbs into the new housing if you are reusing them. Seat each bulb fully in its socket.
- Set the new housing into the opening, start the nuts by hand, then tighten them evenly. Plug the factory connector back in until it clicks.
- Repeat on the other side. Reinstall the trunk liner, reconnect the battery, and check tail, brake, turn, and reverse functions before you drive.