Clear RGB Sequential LED Tail Lights Pair for Ford Mustang (2005-2009)

Upgrade your 2005-2009 Ford Mustang with this black-housing, clear-lens LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.

Fitment

2005-2009 Ford Mustang (5th generation, S197 pre-facelift). Does not fit 2010-2014 Mustang.

Features

• Light-guide LED running light with start-up animation and multi-color (RGB) lighting as shown in the supplier's function images
• LED brake light
• Dynamic sequential LED turn signal
• LED reverse light
• Black ABS housing, {v['c'].lower()} polycarbonate lens
• IP67 sealed, DOT / SAE compliant (per supplier)

RGB note: the supplier lists these lamps as RGB / multi-color but does not document how colors are selected. Contact us before ordering if you need those details.

Signs you need new tail lights

• Cracked, faded or hazy lens
• Water or condensation inside
• Dead LED sections or broken sockets

What's included

• 1 x driver side (left) tail light
• 1 x passenger side (right) tail light
• Connection harness
• All LEDs built in. No extra bulbs needed

Installation: 2005-2009 Ford Mustang (5th gen (S197))

Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 20-30 minutes per side.

1. Open the trunk and peel back the trunk-side trim liner behind the tail light.
2. Unplug the factory connector and remove the retaining nuts from the studs.
3. Pull the lamp straight back off the body.
4. Fit the new lamp on the studs, refit the nuts and connect it with the supplied harness.
5. Refit the trim liner.
6. Test running, brake, sequential turn and reverse on both sides.
7. If the turn signal flashes fast, add a load resistor or LED flasher.

FAQ

What does this fit?

2005-2009 Ford Mustang (5th generation, S197 pre-facelift). Does not fit 2010-2014 Mustang.

Are bulbs included?

Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.

Does it have a sequential turn signal?

Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.

Is this sold as a pair?

Yes: driver side (left) and passenger side (right).

How long does installation take?

About 20-30 minutes per side with basic hand tools.