Clear Sequential LED Tail Lights for Ford Mustang (1996-1998)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Stock SN95 reds look flat next to a clear sequential LED rear—this pair puts a modern chase-turn signature on the 1996-1998 Mustang. GENSSI's Ford Mustang SN95 kit is a vehicle-specific clear sequential LED set with harness that bolts in and plugs into the factory connectors.
Important Fitment Note: Fits 1996-1998 Ford Mustang V6/GT (SN95 coupe and convertible). Clear lens pair with included sequential harness/relay and 3157/3156 LED bulbs.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 1996-1998 | Ford / Mustang V6/GT SN95 | Yes |
Specs
- Style: Chrome housing, clear lens with sequential turn capability
- Bulbs: x6 3157 Red LED + x2 3156 Clear LED included; sequential wire harness + relay included
- Sold as: Clear sequential LED tail light pair with harness
- Fit: Direct-fit clear sequential LED tails for 1996-1998 Mustang SN95 V6/GT
What's included
- 1x Driver clear sequential LED tail light
- 1x Passenger clear sequential LED tail light
- x6 3157 Red LED bulbs
- x2 3156 Clear LED bulbs
- 1x Sequential wire harness pair with relay
Installation — Ford Mustang SN95 (1996-1998)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the trunk. Pull back the rear side trim / carpet to reach the tail light fasteners and harness connectors on each quarter panel.
- Disconnect each factory harness. Remove the mounting fasteners and slide the factory left and right assemblies straight back out of the body openings.
- Install the included 3157 red and 3156 clear LED bulbs into the new clear housings. Connect the included sequential harness and relay between the vehicle plugs and the new assemblies per the harness labeling.
- Seat each new assembly, snug the fasteners while checking quarter-panel and deck gaps, and secure the sequential harness / relay away from sharp edges. Refit the trunk trim.
- Reconnect the battery and test parking, brake, sequential turn, and reverse on both sides.
Buyer FAQ
Do the turns run sequential? Yes. The kit includes a sequential wire harness and relay so the clear LED tails run a sequential turn pattern.
Are LED bulbs included? Yes. You get x6 3157 red LED bulbs and x2 3156 clear LED bulbs plus the sequential harness.
Do I splice into the chassis harness? No. The assemblies and included sequential harness plug into the factory rear connectors—no chassis splicing.