Halogen Headlights Pair for Honda Odyssey (1999-2004)

Give a 1999-2004 Odyssey a clean factory look again. This original-style halogen pair replaces tired or damaged headlights on that generation with chrome-housing, clear-lens assemblies that use the factory H4 bulb and the factory connector. Each lamp is DOT and SAE compliant. This is a direct-fit pair — no splicing.

Fitment

Specs

• Sold as: driver and passenger pair
• Housing / style: original-style chrome housing, clear lens, amber reflector
• Lighting: halogen, H4 bulb type (bulbs not included)
• DOT and SAE compliant
• New aftermarket assemblies, designed to replace the factory halogen units

Bulb size: H4 (not included).

In the Box

• Driver-side headlight assembly
• Passenger-side headlight assembly

Interchange References

Replaces the original halogen housings used under 33151S0XA01 / 33151-S0X-A01 (driver) and 33101S0XA01 / 33101-S0X-A01 (passenger), and Partslink HO2502114 / HO2503114.

Installation: Honda Odyssey (1999-2004)

On the 1999-2004 Odyssey, the front bumper cover comes off so you can reach the headlight bolts. Professional installation and beam aiming are recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.

1. Open the hood. Remove the clips along the upper grille and radiator-support area (typically eleven), then the fasteners under the bumper cover (typically four) and the 10 mm and 8 mm fasteners at each fender. Unplug the fog-lamp connectors if the van is equipped with fogs, and pull the bumper cover forward off its guides.
2. Remove the four 10 mm bolts that hold each headlight. Pull the assembly forward off its alignment tabs, and unplug the factory connector. Do not pull on the wiring. Transfer your existing H4 bulbs into the new housings, or install new H4 bulbs — bulbs are not included with this pair.
3. Connect the factory-style connector to each new lamp, seat the assembly on the alignment tabs, and start the four 10 mm bolts. Repeat on the other side.
4. Reinstall the bumper cover, fender fasteners, under-bumper clips, and upper clips, reconnect any fog-lamp connectors, reconnect the battery, and test low beam and high beam. Aim the lamps on a level surface before driving at night.

Frequently Asked Questions

Which vehicles do these headlights fit?
1999-2004 Honda Odyssey only. They will not fit 2005-2010 or 2011-2017 Odyssey, which use later housings. Compare your current lamps with our photos before ordering.

Will they fit a 2005-up Odyssey?
No. This pair is the 1999-2004 halogen housing only.

Are these a pair or a single lamp?
This is a complete driver and passenger pair, not a single-side lamp.

Do they include bulbs?
No. H4 halogen bulbs are not included. Transfer your existing bulbs or have new H4 bulbs ready before you install.

How are they installed on a 1999-2004 Odyssey?
On this generation, the bumper cover comes off first. Remove the upper grille-area clips, the under-bumper fasteners, and the 10 mm and 8 mm fender fasteners on both sides, and unplug the fog lamps if equipped. Then remove the four 10 mm bolts on each headlight, unplug the harness, transfer your H4 bulbs, and seat the new assembly on its alignment tabs. Reinstall the bumper cover and aim the lamps before nighttime driving.