Halogen Headlights Pair w/ Bulbs for Ford Taurus (2016-2019)

Replace yellowed or cracked headlights on your 2016-2019 Ford Taurus with factory halogen headlights with this brand-new pair.

Fitment

Will NOT fit: Taurus with HID headlights; 2010-2015 Taurus; Police Interceptor unless lamp matches.

Common Reasons to Replace

• Yellowed, hazy, or oxidized lenses reducing light output
• Cracked lens or broken mounting tabs
• Moisture or condensation inside the housing
• Collision damage

Specs

• Headlight: HB3
• Turn signal: 3457NAK
• Side marker: WY5W
• DOT compliant
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: FG1Z13008K. Partslink: FO2502361, FO2503361.

What's Included

• 1 x Driver side headlight assembly
• 1 x Passenger side headlight assembly
• Bulbs per listing

Installation

1. Lights off, open the hood. Remove the six push pins on the front trim cover and the three upper bumper-cover screws.
2. Remove the inboard push pin and the two headlamp screws, then the three wheel-housing fasteners and the two outer lower bumper fasteners.
3. Pull the bumper cover outward about 3 cm off the fender, then forward about 10 cm. Pull the headlamp out of its lower mount, lift it and unplug it.
4. Install the new lamp (upper/front bolts 28 lb-in, side bolt 62 lb-in), refit the cover and aim.

Steps compiled from Ford Taurus owner manual (Removing a Headlamp) and Ford Taurus service manual. Professional installation and headlight aiming are recommended.

FAQs

What bulbs do these headlights use?
Per the listing: HB3, 3457NAK turn signal and WY5W side marker.

Will these fit a 2013-2015 Taurus?
Check your lamp against the listing photos; this pair is listed for 2016-2019.

Do I need to remove the front bumper to replace these headlights?
Partly. Per the Ford owner manual you release the front bumper cover from the fender and pull it forward about 4 in; the service manual removes it fully.

Can I install HID or LED kits?
Yes. This is a halogen housing, so a plug-in LED or HID kit in your factory bulb size can be used. Aim the headlights afterward.