JDM Red / Clear LED Tail Lights for Subaru Forester (2003-2008)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Cloudy SG Forester reds look tired next to red/clear LED parking/brake housings—this pair keeps the OE look with a sharper night signature. GENSSI's 2003-2008 Subaru Forester kit is a vehicle-specific JDM red/clear LED tail pair that bolts in and plugs into the factory harness.
Important Fitment Note: Fits 2003-2008 Subaru Forester (X/XS). Red/clear OE-style housings with built-in LED parking/brake—not altezza non-LED tails.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2003-2008 | Subaru / Forester X/XS | Yes |
Specs
- Style: Chrome housing, red / clear lens with built-in LED parking / brake
- Bulbs: Built-in LED parking / brake; 7440A signal and 921 reverse — reuse or replace separately
- Sold as: JDM red/clear LED tail light pair
- Fit: Direct-fit red/clear LED tails for 2003-2008 Subaru Forester SG
Interchange
84201-SA030, 84201-SA170, 84201-SA370, 84201-SA020, 84201-SA160, 84201-SA360, SU2800108, SU2800017, SU2800122, SU2801108, SU2800117, SU2801122
What's included
- 1x Driver red/clear LED tail light
- 1x Passenger red/clear LED tail light
Installation — Subaru Forester (2003-2008)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the hatch. Pull back the rear side trim to reach the tail light mounting nuts and harness connectors on each quarter panel.
- Disconnect each harness. Remove the mounting nuts and slide the factory left and right assemblies straight back out of the body openings.
- Seat each new red/clear LED assembly, reconnect the plugs, and snug the fasteners while checking quarter-panel gaps. Transfer or install 7440A signal and 921 reverse bulbs as needed.
- Refit the hatch trim, reconnect the battery, and test parking / brake LED, turn, and reverse on both sides.
Buyer FAQ
Are these altezza-style non-LED tails? No. These are OE-design red/clear housings with built-in LED parking/brake—not outdated non-LED altezza lamps.
Which bulbs do I reuse? Signal uses 7440A and reverse uses 921. Parking and brake are built-in LED.
Do I splice wiring? No. After hatch access, the assemblies bolt in and plug into the factory harness.