LED Projector Sequential Clear Corner Headlights for Chevy Silverado (2007-2014)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Stock GMT900 lamps look soft next to black LED projectors with sequential clear corners—this pair sharpens the Silverado face. GENSSI's Chevy Silverado kit is a vehicle-specific LED projector set that bolts in and plugs into the factory harness.
Important Fitment Note: Fits Chevy Silverado 1500 (2007-2013) and Silverado 2500HD / 3500HD (2007-2014). 1500 ends at 2013—HD trucks run through 2014.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2007-2013 | Chevy / Silverado 1500 | Yes |
| 2007-2014 | Chevy / Silverado 2500HD / 3500HD | Yes |
Specs
- Style: Black housing, clear corner, LED projector beams with sequential signal
- Bulbs: Full LED beam projectors with sequential clear-corner signal sections as equipped
- Sold as: LED projector sequential clear-corner headlight pair
- Fit: Direct-fit for Silverado 1500 (2007-2013) and Silverado 2500HD / 3500HD (2007-2014)
Interchange
25962804, 22853027, 15912783, 25833678, 25962805, 22853028, 15912784, 25833679
What's included
- 1x Driver LED projector sequential clear-corner headlight
- 1x Passenger LED projector sequential clear-corner headlight
Installation — Chevy Silverado GMT900 (2007-2014)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the hood. Remove the grille, upper bumper cover fasteners, and any headlight access brackets needed to reach the retaining bolts.
- Support each headlight, remove the retaining bolts / clips, press the connector lock tabs, disconnect the harnesses, and pull the factory lamp straight forward off the locating pins.
- Transfer any brackets or adjusters from the factory lamps only where the new assemblies clearly lack them.
- Align each new LED projector on the locating pins, reconnect the harness plugs until the lock tabs click, snug the fasteners evenly while checking hood / fender / grille gaps, and leave trim loose until testing is done.
- Reconnect the battery, test low beam, high beam, parking, sequential signal, and DRL if equipped, aim the beams on a level surface, then refit the grille and bumper trim.
Buyer FAQ
Do 2014 Silverado 1500 trucks fit? No. 1500 fitment is 2007-2013. 2014 coverage is Silverado 2500HD / 3500HD only.
Are these halogen projectors? No. These are LED projector assemblies with sequential clear-corner signal sections—not halogen beam housings.
Do I splice wiring? No. After grille / upper bumper access, the assemblies bolt in and plug into the factory harness.