Red and Amber Halogen Tail Lights Pair for Chrysler PT Cruiser (2001-2005)
$99.95
Ir directamente a la información del producto
Red and Amber Halogen Tail Lights Pair for Chrysler PT Cruiser (2001-2005)
$99.95
DS-5288742AG
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Chrysler PT Cruiser (2001-2005) pre-facelift models that use this red and amber teardrop housing. They will not fit 2006-2010 PT Cruiser, which uses a different red and clear lens. Compare your current housings with our photos before ordering.
Restore a 2001-2005 PT Cruiser with this red and amber halogen pair. Each teardrop housing has an amber upper turn section and a red lower tail and brake section. 3156 turn bulbs and 3157 brake bulbs are included. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2001-2005 | Chrysler PT Cruiser | Pre-facelift red and amber halogen housing. Not 2006-2010 |
Specs
- Sold as: a driver and passenger pair
- Style: red and amber teardrop lens
- Lighting: halogen tail, brake, and turn; 3156 and 3157 bulbs included
- DOT certified
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger red and amber halogen tail lights
- 3156 turn bulbs and 3157 brake bulbs
Interchange References
Replaces original-style 2001-2005 PT Cruiser tail lights commonly crossed with 5288742AG, 5288743AG, 5288742AF, 5288743AF, CH2801145, and CH2800145.
Installation: Chrysler PT Cruiser (2001-2005)
On the pre-facelift PT Cruiser these tail lights mount at the rear corners, with the fasteners reached with the hatch open. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the hatch. Locate the tail light fasteners on the back of the housing; pull back any interior trim that covers them.
- Unplug the factory connector.
- Remove the fasteners and pull the housing straight out of the opening. Do not pry on the lens.
- Install the included 3156 and 3157 bulbs, seating each bulb fully in its socket.
- Set the new housing into the opening, start the fasteners by hand, then tighten them evenly. Plug the factory connector back in until it clicks.
- Repeat on the other side. Reinstall any trim, reconnect the battery, and check tail, brake, and turn functions before you drive.