Red and Clear Halogen Tail Lights Pair for Ford F-150 Styleside (2004-2008)
$99.95
Ir directamente a la información del producto
Red and Clear Halogen Tail Lights Pair for Ford F-150 Styleside (2004-2008)
$99.95
DS-5L3Z13405CA
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Ford F-150 Styleside (2004-2008). For 2004 they fit the new body style only — they will not fit 2004 F-150 Heritage, which uses the earlier 1997-2003 lamp. They will not fit Flareside beds, Super Duty, or 2009-up F-150. This is a halogen pair, not a sequential LED pair. Compare your current housings with our photos before ordering.
Refresh a 2004-2008 F-150 Styleside with this halogen tail light pair. You get driver and passenger assemblies with a red and clear lens in a chrome housing. Tail, brake, turn, and reverse functions use your existing halogen bulbs — bulbs are not included, so reuse the factory bulbs if they are still good. The housings use the factory mounting points and factory-style connectors.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2004-2008 | Ford F-150 | Styleside, 2004 new body style only. Not Heritage, not Flareside, not Super Duty |
Specs
- Sold as: a driver and passenger pair
- Style: chrome housing, red and clear lens
- Lighting: halogen tail, brake, turn, and reverse; bulbs not included
- DOT certified
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger red and clear halogen tail lights
Interchange References
Replaces original-style 2004-2008 F-150 Styleside tail lights commonly crossed with 5L3Z-13405-CA, 5L3Z-13404-CA, 6L3Z-13405-BA, 6L3Z-13404-BA, FO2800182, and FO2801182.
Installation: Ford F-150 Styleside (2004-2008)
On the 2004-2008 F-150 Styleside these tail lights bolt to the bedside and are reached with the tailgate open. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the tailgate. From the bed opening, locate the bolts on the face of each tail light housing.
- Remove the bolts and pull the housing straight back out of the bedside. Do not pry on the lens.
- Unplug the factory connector.
- Plug the factory connector into the new housing until it clicks, set the housing into the opening, start the bolts by hand, then tighten them evenly.
- Repeat on the other side. Reconnect the battery and check tail, brake, turn, and reverse functions before you drive.