Red and Clear LED Tail Lights Pair for Nissan Pickup (1986-1997) / D21 (1986-1994)

Red and Clear LED Tail Lights Pair for Nissan Pickup (1986-1997) / D21 (1986-1994)

$184.95
Ir directamente a la información del producto
Red and Clear LED Tail Lights Pair for Nissan Pickup (1986-1997) / D21 (1986-1994)
  • Red and Clear LED Tail Lights Pair for Nissan Pickup (1986-1997) / D21 (1986-1994)
  • Driver and passenger red and clear LED tail lights for Nissan Pickup 1986-1997, front view
  • 1986-1997 Nissan Pickup and 1986-1994 D21 red and clear LED tail light pair at an angle
  • 1986-1997 Nissan Pickup red and clear LED tail light pair lit
  • Close-up of the LED array and clear reverse section on a Nissan D21 tail light
  • Back housings of the 1986-1997 Nissan Pickup and D21 LED tail light pair
  • Factory-style connector on a 1986-1997 Nissan Pickup LED tail light
  • Included load resistor for the 1986-1997 Nissan Pickup LED tail light pair
Red and Clear LED Tail Lights Pair for Nissan Pickup (1986-1997) / D21 (1986-1994)

Red and Clear LED Tail Lights Pair for Nissan Pickup (1986-1997) / D21 (1986-1994)

$184.95
DS-B65503B300-LED

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

Fitment warning: These tail lights fit Nissan Pickup (1986-1997) and Nissan D21 (1986-1994) only. They will not fit Nissan Frontier or later compact pickups, which use a different tail light. Compare your current housings with our photos before ordering.

Replace worn D21 / Hardbody tails with this red and clear LED pair. You get driver and passenger chrome-housing assemblies with an LED tail and brake array and a clear reverse section. Bulbs and a load resistor are included — mount the resistor if your truck's flasher needs it to keep the turn signal from hyper-flashing. The housings use the factory mounting points and factory-style connectors.

Installation for 1986-1997 Nissan Pickup and 1986-1994 D21

  1. Open the tailgate so you can reach the screws on the inner edge of each bedside lamp.
  2. Remove the screws that hold the assembly to the bedside.
  3. Pull the housing straight back and unplug the factory connector.
  4. Install the included bulbs if they are not already seated, plug the new housing into the factory-style connector, and mount the included load resistor if your truck requires it.
  5. Seat the housing on the factory mounting points, tighten the screws, and repeat on the other side. Check tail, brake, turn, and reverse functions before closing the tailgate.

A do-it-yourself installer can usually finish both sides in about 30-45 minutes with basic hand tools. Always disconnect the negative battery cable before you start and torque fasteners to the factory specification.

También te puede interesar