Smoked Sequential LED Tail Lights Pair for Mini Cooper Clubman F54 (2016-2019)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Upgrade your 2016-2019 Mini Cooper Clubman F54 with this black-housing, smoked-lens LED tail light pair. A light-guide running lamp with start-up animation, bright LED brake section, dynamic sequential turn signal and LED reverse light replace the factory lamps and bolt into the original mounting points.
Fitment
| Years | Make / Model | Generation |
|---|---|---|
| 2016-2019 | Mini / Cooper Clubman | F54 pre-facelift |
2016-2019 Mini Cooper Clubman (F54, pre-facelift), incl. Cooper S. Listing says 2015-2019; US F54 sales began with model year 2016.
Features
- Light-guide LED running light with start-up animation
- LED brake light
- Dynamic sequential LED turn signal
- LED reverse light
- Black ABS housing, {v['c'].lower()} polycarbonate lens
- IP67 sealed, DOT / SAE compliant (per supplier)
Signs you need new tail lights
- Cracked, faded or hazy lens
- Water or condensation inside
- Dead LED sections or broken sockets
What's included
- 1 x driver side (left) tail light
- 1 x passenger side (right) tail light
- Connection harness
- All LEDs built in. No extra bulbs needed
Installation: 2016-2019 Mini Cooper Clubman F54 (F54 pre-facelift)
Tools: 10 mm socket, Phillips screwdriver, plastic trim tool. About 15-20 minutes per side.
- Open the rear split door on that side and remove the inner door trim access cover behind the lamp.
- Unplug the factory connector and remove the retaining nuts from the lamp studs.
- Pull the lamp straight back out of the door.
- Fit the new lamp on the studs, refit the nuts and connect it with the supplied harness.
- Refit the access cover.
- Test running, brake, sequential turn and reverse on both sides.
- If the turn signal flashes fast, add a load resistor or LED flasher.
FAQ
What does this fit?
2016-2019 Mini Cooper Clubman (F54, pre-facelift), incl. Cooper S. Listing says 2015-2019; US F54 sales began with model year 2016.
Are bulbs included?
Yes. The lamps are fully LED with every light source built in, so no extra bulbs are needed.
Does it have a sequential turn signal?
Yes. The turn section lights in a dynamic sequential sweep, and the running light plays a start-up animation.
Is this sold as a pair?
Yes: driver side (left) and passenger side (right).
How long does installation take?
About 15-20 minutes per side with basic hand tools.