GENSSI hero — all clear tail lights pair for Honda Accord sedan (2006-2007) on white

All Clear Tail Lights Pair for Honda Accord Sedan (2006-2007)

$167.95
Passer aux informations sur le produit
GENSSI hero — all clear tail lights pair for Honda Accord sedan (2006-2007) on white

All Clear Tail Lights Pair for Honda Accord Sedan (2006-2007)

$167.95
DS-ACCORD-SEDAN-TAIL-ALL-CLR-PAIR-2006-2007

Free shipping to the lower 48 · Returns & refunds · Questions? Contact us

The 2006-2007 Accord sedan's red lenses look heavy from behind, and this all-clear pair lets the factory LED brake board show through a brighter face while the amber 7440 turn still reads at night. GENSSI's set is a left and right housing for that sedan only, not the coupe and not a 2003-2005 lamp, and the board and turn socket transfer with no splicing.

Important Fitment Note: Four-door sedan only, and only 2006-2007. The 2006-2007 coupe uses a different lamp, and the 2003-2005 sedan uses a different lamp. The factory LED brake board and the amber 7440 turn socket have to move onto these housings. They are not in the box.

Fitment

YEAR MAKE / MODEL FITS
2006-2007 Honda / Accord sedan, all trims including Hybrid Yes
2006-2007 Honda / Accord coupe No
2003-2005 Honda / Accord sedan No

Specs

  • Style: Chrome housing with an all-clear lens; polycarbonate lens with UV protection and high impact resistance. The factory LED brake board transfers into this housing
  • Bulbs: The brake and parking section is the factory LED board, which is not in the box. Move that board over. The turn is an incandescent amber 7440. The turn socket and bulb are not included. No splicing
  • Sold as: Pair — left and right tail light housings. The factory LED board and 7440 turn socket move over
  • Fit: Direct replacement for every 2006-2007 Honda Accord sedan, including LX, SE, EX, EX-L, and Hybrid. The LED board and turn socket transfer. No splicing

Interchange

33551-SDA-A32, 33501-SDA-A32, HO2818130, HO2819130

What's included

  • 1x Driver (left) all-clear tail light assembly
  • 1x Passenger (right) all-clear tail light assembly

Installation — Honda Accord Sedan (2006-2007)

  1. Open the trunk. Pry the trim clips at the corner of the trunk lining with a flat screwdriver wrapped in tape, and fold the lining forward so the lamp studs are visible.
  2. Remove the 8 mm nuts from the lamp studs with an 8 mm socket, a 1/4-inch ratchet, and a short extension. Set the nuts where they cannot fall into the trunk drain.
  3. From outside the car, pull the lamp straight back off its locating pins. If it sticks, wiggle it. Do not pry on the lens.
  4. Unplug the connector on the LED board. That board is the parking and brake section. Release it from the old housing and seat it in the open back of the new housing, in the same orientation, then refit the fasteners that held it so the board sits flat on the reflector.
  5. Twist the turn socket a quarter turn counterclockwise and pull it out of the old housing. It takes the original amber 7440 bulb, which stays in that socket. Lock the socket into the new housing a quarter turn clockwise. The 7440 bulb is not in the box.
  6. Line the locating pins up and press the lamp on until it sits flush. Start the 8 mm nuts by hand and snug them. About 5 Nm is enough. Do not crush the plastic. Refit the trunk lining and the clips.
  7. Check parking, brake, and both turn signals. If the brake section stays dark, the LED board is not seated or its connector is not plugged in.

Buyer FAQ

Is the LED board in the box? No. These are clear housings. Move the factory LED board from your 2006-2007 sedan into the new housing. That board is the parking and brake section. The amber 7440 turn bulb and its socket move over too.

Does this fit the coupe or a 2003-2005 sedan? No. This pair is the 2006-2007 four-door sedan only. The coupe from those years is a different lamp, and the 2003-2005 sedan is a different lamp.

Which Accords fit, and what is in the box? Every 2006-2007 Accord sedan, including LX, SE, EX, EX-L, and Hybrid. You get one driver-side housing and one passenger-side housing. It replaces 33551-SDA-A32 on the left and 33501-SDA-A32 on the right. No bulbs are packed with it.

Vous aimerez peut-être aussi