All Clear Tail Lights for Subaru Impreza / WRX Sedan (2008-2014)
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Stock sedan reds look soft next to an all-clear rear—this pair brightens Impreza (2008-2011) and WRX (2012-2014) 4-door night presence. GENSSI's Subaru sedan kit is a vehicle-specific clear tail pair that bolts in and plugs into the factory harness.
Important Fitment Note: Fits Subaru Impreza 4-door sedan (2008-2011) and WRX 4-door sedan (2012-2014) only—not hatchback / wagon bodies.
Fitment
| YEAR | MAKE / MODEL | FITS |
|---|---|---|
| 2008-2011 | Subaru / Impreza 4-Door Sedan | Yes |
| 2012-2014 | Subaru / WRX 4-Door Sedan | Yes |
Specs
- Style: Chrome housing, all-clear lens
- Bulbs: x2 921 clear + x2 7443 red bulbs included; 7440 signal as equipped
- Sold as: All-clear tail light pair
- Fit: Direct-fit all-clear tails for Impreza sedan (2008-2011) and WRX sedan (2012-2014) 4-door only
Interchange
84912FG130, 84912FG120
What's included
- 1x Driver all-clear tail light
- 1x Passenger all-clear tail light
- x2 921 clear bulbs
- x2 7443 red bulbs
Installation — Subaru Impreza / WRX Sedan (2008-2014)
- Park on level ground, set the parking brake, switch lights and ignition off, and disconnect the negative battery cable.
- Open the trunk. Pull back the rear side trim / carpet to reach the tail light mounting nuts and harness connectors on each quarter.
- Disconnect each harness. Remove the mounting nuts and slide the factory left and right assemblies straight back out of the body openings.
- Install the included 921 clear and 7443 red bulbs into the new housings. Seat each new assembly, reconnect the plugs, and snug the fasteners while checking quarter-panel and deck gaps.
- Refit the trunk trim, reconnect the battery, and test parking, brake, turn, and reverse on both sides.
Buyer FAQ
Will these fit an Impreza hatch? No. Fitment is 4-door sedan bodies only—Impreza sedan 2008-2011 and WRX sedan 2012-2014.
Are bulbs included? Yes. The kit includes x2 921 clear and x2 7443 red bulbs for the assemblies.
Do I splice wiring? No. After trunk access, the assemblies bolt in and plug into the factory harness.