Black Halogen Tail Lights Pair for Acura TL (2004-2008)
$136.95
Passer aux informations sur le produit
Black Halogen Tail Lights Pair for Acura TL (2004-2008)
$136.95
DS-33501SEPA01
Free shipping to the lower 48 · Returns & refunds · Questions? Contact us
Fitment warning: These tail lights fit Acura TL (2004-2008) all models. They will not fit 1999-2003 TL or 2009-2014 TL. Compare your current housings with our photos before ordering.
Replace worn 2004-2008 TL tails with this black halogen pair. Each housing has a clear lens over a two-bar black housing and uses factory-style connectors. T20 signal bulbs are included; reuse your remaining factory bulbs for the other functions.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 2004-2008 | Acura TL | All models; black-housing halogen tail lights |
Specs
- Sold as: a driver and passenger pair
- Style: black housing, clear lens, two-bar layout
- Lighting: halogen; T20 signal bulbs included (other bulbs not included)
- DOT certified
- 12 V
- New aftermarket assemblies
In the Box
- Driver and passenger black halogen tail lights
- 2 T20 signal bulbs
Interchange References
Replaces original-style 2004-2008 TL tail lights commonly crossed with 33501-SEP-A01, 33551-SEP-A01, AC2819104, and AC2818104.
Installation: Acura TL (2004-2008)
On the third-generation TL these tail lights bolt to the rear quarter, with the nuts reached from inside the trunk after the side trunk trim is pulled back. Professional installation is recommended. Switch off the lights and ignition, set the parking brake, and disconnect the negative battery cable before you start.
- Open the trunk and carefully pull back the side trunk trim enough to reach the tail light nuts.
- Unplug the factory connector from the back of the housing.
- Remove the retaining nuts and pull the housing straight back out of the quarter panel. Do not pry on the lens.
- Install the included T20 signal bulbs and transfer any remaining factory bulbs into the new housing. Seat each bulb fully.
- Set the new housing into the opening, start the nuts by hand, then tighten them evenly. Plug the factory connector back in until it clicks.
- Repeat on the other side. Reinstall the trunk trim, reconnect the battery, and check tail, brake, turn, and reverse functions before you drive.