Black HID Projector Headlights Pair w/ LED DRL for Ford Mustang HID (2013-2014)

Replace oxidized or cracked headlights on your 2013-2014 Ford Mustang with factory HID/Xenon headlights with this brand-new pair of black HID projector headlights with LED running lights. Half assembly: reuse your D3S bulbs and ballasts.

Fitment

Will NOT fit: 2013-2014 Mustang with factory halogen headlights; 2010-2012 Mustang; 2015+ Mustang.

Common Reasons to Replace

• Yellowed, hazy, or oxidized lenses reducing light output
• Cracked lens or broken mounting tabs
• Moisture or condensation inside the housing
• Collision damage

Specs

• Housing: Black
• High/low beam: D3S HID (NOT included)
• Turn signal: 7444NA (included)
• Running light: LED
• DOT compliant
• Quantity: Pair (Left + Right)
• Condition: New

Interchange Part Numbers

OEM: DR3Z13008D. Partslink: FO2518113, FO2519113.

What's Included

• 1 x Driver side headlight assembly
• 1 x Passenger side headlight assembly
• 7444NA turn signal bulbs
• Half assembly: HID bulbs, ballasts, and high-voltage wires are NOT included; reuse yours

Installation

1. Disconnect the negative battery cable and remove the front bumper cover.
2. Remove the pin-type retainer and the three 10 mm headlamp bolts, pull the lamp out and unplug it.
3. Lay the lamp face-down, remove the four T10 Torx ballast-cover screws, unplug and remove the ballast.
4. Rotate the bulb locking cover counterclockwise, unplug and release the D3S bulb, and transfer the bulb, ballast and harness to the new lamp.
5. Install the lamp, tighten the bolts to 8 Nm (71 lb-in), test low, high, turn and DRL, refit the bumper and aim.

Steps compiled from Ford 2014 Mustang workshop manual (417-01), LMR 2013-2014 Mustang HID headlight video and AllFordMustangs. Professional installation and headlight aiming are recommended.

FAQs

What bulb sizes do these headlights use?
High/low beam D3S HID (not included; reuse yours), turn signal 7444NA (included), running light LED.

Will these fit a 2010-2012 Mustang?
No. These are 2013-2014 S197 facelift lamps for cars with factory HID.

How do I move my ballast over?
Lay the old lamp face-down, remove the four T10 Torx screws on the ballast cover, unplug the ballast and transfer it, the D3S bulb and the bulb-to-ballast harness to the new lamp.

Can I install HID or LED kits?
Not applicable. These are factory-style HID housings with built-in LED running lights; reuse your D3S bulbs.